Cams

2.7 V6 30v biturbo - 380 bhp
rtd
Cruising
Posts: 2542
Joined: Fri Sep 29, 2006 2:02 pm

Cams

Post by rtd » Mon Jul 27, 2009 9:35 pm

well its happened to me as well thankfully its been caught early so no real serious damage done.

been reading some previous posts on what parts people have had replaced and there is a real difference between each job - i suppose thats down to the wear each car has shown?!

my car is standard and has done 66k and was serviced every 8k miles......
Volvo XC90
C7 - RS6
C6 - RS6
B5 - RS4

User avatar
Contigo
Top Gear
Posts: 1728
Joined: Fri Mar 24, 2006 12:32 pm

RE: Cams

Post by Contigo » Mon Jul 27, 2009 10:01 pm

Standard car mate?

Sorry to hear this, it seems it could happen to every single one of them at some point.
2001 Avus Silver RS4 B5 60k on clock, MRC Custom Remap, Sunroof, Bluetooth prep

2006 Daytona Grey RS4 B7, RNS-E - SOLD

2006 BMW M6 - GONE

User avatar
Contigo
Top Gear
Posts: 1728
Joined: Fri Mar 24, 2006 12:32 pm

RE: Cams

Post by Contigo » Mon Jul 27, 2009 10:02 pm

Just reread it again and seen it's standard,it's early here in Singapore and jet lag is kicking in!!!

So the next question is, what alerted you to the fact? was it a routine check for cam wear or lumpy and loud tickover?
2001 Avus Silver RS4 B5 60k on clock, MRC Custom Remap, Sunroof, Bluetooth prep

2006 Daytona Grey RS4 B7, RNS-E - SOLD

2006 BMW M6 - GONE

rtd
Cruising
Posts: 2542
Joined: Fri Sep 29, 2006 2:02 pm

RE: Cams

Post by rtd » Mon Jul 27, 2009 10:06 pm

hi phil, had the car inspected for it especially. i used to listen out for the ticking noise however, reading other owners stories that they never picked up on it, i thought it best to get checked. my advice to all is get your cars checked out.
Volvo XC90
C7 - RS6
C6 - RS6
B5 - RS4

User avatar
Contigo
Top Gear
Posts: 1728
Joined: Fri Mar 24, 2006 12:32 pm

RE: Cams

Post by Contigo » Mon Jul 27, 2009 10:17 pm

Awww sorry man!! That's a real sickner but as you good to catch it before something worse happens. I'm going to get mine checked soon.
2001 Avus Silver RS4 B5 60k on clock, MRC Custom Remap, Sunroof, Bluetooth prep

2006 Daytona Grey RS4 B7, RNS-E - SOLD

2006 BMW M6 - GONE

eyeball
2nd Gear
Posts: 183
Joined: Mon Apr 06, 2009 11:47 pm

Post by eyeball » Tue Jul 28, 2009 12:50 am

Sorry to hear about your cams, the worst thing about it is you may not even know its happening. I had mine checked a few months back at fontain. They said they looked fine but to be honest I dont know if they checked it properly, i'd much prefer to see it with my own eyes because if there was a problem I bet there'd be no come back for them. I just hope my warrenty direct covers these sort of problems?? :?

rtd
Cruising
Posts: 2542
Joined: Fri Sep 29, 2006 2:02 pm

Post by rtd » Tue Jul 28, 2009 8:35 am

eyeball wrote:Sorry to hear about your cams, the worst thing about it is you may not even know its happening. I had mine checked a few months back at fontain. They said they looked fine but to be honest I dont know if they checked it properly, i'd much prefer to see it with my own eyes because if there was a problem I bet there'd be no come back for them. I just hope my warrenty direct covers these sort of problems?? :?
hi mate thanks for the kind words. defo get yours inspected better to be safe than sorry.....
Volvo XC90
C7 - RS6
C6 - RS6
B5 - RS4

User avatar
TopBear
4th Gear
Posts: 924
Joined: Mon Jul 03, 2006 12:41 am
Location: Glasgow

Post by TopBear » Tue Jul 28, 2009 9:59 am

eyeball wrote: I just hope my warrenty direct covers these sort of problems?? :?
They did for me, but I had to pay up first, and then put some pressure on them to pay me back eventually.
:blackrs4: B5 RS4, MRC Remap, Milltek, RS6\B7 Brakes, Black\Carbon

eyeball
2nd Gear
Posts: 183
Joined: Mon Apr 06, 2009 11:47 pm

Post by eyeball » Tue Jul 28, 2009 4:12 pm

So basically if they paid out once with you then there shouldnt be any reason why they won't pay out for someone else with the same problem...So who sorted your engine out and what was the cost??

User avatar
Norrs2
3rd Gear
Posts: 495
Joined: Fri Oct 06, 2006 12:57 pm
Location: Perthshire, Scotland

Post by Norrs2 » Wed Jul 29, 2009 6:35 pm

Just clocked onto all these posts about Cam wear! Yikes!!!

Well, I've listened to my cold and let it heat up. With the car sitting ticking over, I can hear something more like a slight mechanical whirring, but nothing I could say is "ticking". When you take the car anything above idle, there nothing at all - totally smooth and quiet. No eratic idling at all either.

I have the bonnet open but it's really dificult to detect what the noise is, but I would liken it more to a pulley noise or something like a mechanical noise, but not ticking exactly. It's not very loud though.

But it could easily be coming from the Cam area too, I can'tell!

Is it definately a "ticking" noise you hear?

Car has done 97k and not been serviced on the long life cycle - allthough that doesn't seem to make any difference.

Not due another trip to MRC until 120k for Cambelt, what would you do?

@rtd - Sorry to hear about your bad luck (or good depending on how you look at it!)
B5 RS4 - Santorin Blue Pearl
B7 Brakes
MRC Custom Re-Map
Loba Camshafts
Wagner Downpipes
Miltek Cat Back SS Exhaust

1988 Pearl White MB Ur quattro (Genesis)

User avatar
TopBear
4th Gear
Posts: 924
Joined: Mon Jul 03, 2006 12:41 am
Location: Glasgow

Post by TopBear » Wed Jul 29, 2009 7:27 pm

eyeball wrote:So basically if they paid out once with you then there shouldnt be any reason why they won't pay out for someone else with the same problem...So who sorted your engine out and what was the cost??
In theory, ...yes, but you know how these companies work, they will try anything to wriggle out of a claim.

Their principle argument was that it wasnt a 'sudden failure', which is what they provide cover for, rather, it was progressive wear which caused cam wear, which wasnt covered.

Happy to discuss the specifics of my case via PM if anyone is struggling with them
:blackrs4: B5 RS4, MRC Remap, Milltek, RS6\B7 Brakes, Black\Carbon

rtd
Cruising
Posts: 2542
Joined: Fri Sep 29, 2006 2:02 pm

Post by rtd » Wed Jul 29, 2009 7:53 pm

thanks Norrs2.

my car also didn't display any of the ticking noises etc. my advice would be to get it checked rather than waiting and risking it - its not as if these engines are cheap!

3hrs labour to check them against 10k for a new engine!!!
Volvo XC90
C7 - RS6
C6 - RS6
B5 - RS4

User avatar
missmouse
2nd Gear
Posts: 104
Joined: Fri Jun 19, 2009 2:27 pm
Location: scotland

Post by missmouse » Wed Aug 26, 2009 6:04 pm

all this talk about cams wearing, I assume the cams snap or something to cause engine failure?
Surely just the lobes wearing out wont cause engine failure? Just lack of power & tappet noise?
Fit new cam & all is well? NO? am i missing something here? :?

ollys
4th Gear
Posts: 816
Joined: Fri Feb 22, 2008 1:05 am

Post by ollys » Wed Aug 26, 2009 8:10 pm

missmouse wrote:all this talk about cams wearing, I assume the cams snap or something to cause engine failure?
Surely just the lobes wearing out wont cause engine failure? Just lack of power & tappet noise?
Fit new cam & all is well? NO? am i missing something here? :?
Yep - The cam lobe wears down, makes an indent in the lifter, and eventually wears the lifter through dropping a valve into the head and boom!

See here: http://audisrs.com/about4067.html&highlight=

Will give you nightmares :twisted:

User avatar
missmouse
2nd Gear
Posts: 104
Joined: Fri Jun 19, 2009 2:27 pm
Location: scotland

Post by missmouse » Wed Aug 26, 2009 8:29 pm

Ah! it must be going for a bit before that happens tho?

Post Reply

Return to “RS4 (B5 Typ 8D) 1999-2001”

Who is online

Users browsing this forum: No registered users and 79 guests