VAGCOM

Post by **SimonS4MTM** » Wed Dec 14, 2005 2:51 pm

Does anyone get this when they scan for faults.

Address 25: Immobilizer
Controller: Bit teA dre ss
Component: e 17 eingeben
No Faults Found
or DTCs not supported by controller
or a communication error occurred

I have always had the same message and was wondering if it is common or if i have a comunication problem with the controller.

Post by **ChipHazzard** » Wed Dec 14, 2005 3:02 pm

I had the same code on mine and from memory it hasnt come back since i cleared it. I'll try and remember to run a scan tonight

Post by **S2tuner** » Wed Dec 14, 2005 3:13 pm

This means that the immobiliser is not at address 25 (which was used on older cars) but at address 17, which is the instruments cluster.

HTH,

Mihnea

Post by **gavsteryoung** » Wed Dec 14, 2005 3:22 pm

Simon, I get the same......

Could be something to do with the presets on the VAGCOM when picking B5 A4. I have often thought about getting it to scan every address possible.....

Post by **KayGee** » Wed Dec 14, 2005 7:32 pm

If I remember correctly you can "fix" that in the label file. Sure it is on the vagcom forum somewhere.

RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

VAGCOM

VAGCOM

RE: VAGCOM

RE: VAGCOM

RE: VAGCOM

RE: VAGCOM

Who is online