Hi. Ive not long owned my B7 cabrio but as the months roll on I am noticing more and more things about it. The latest is it looked to me like the holes in the brake discs were a little smaller than I had seen elsewhere. When I checked more closely the rear ones are slightly bigger than the front and they are full of gunge (brake dust i presume). Is it ok to just remove the wheels and drill them all out ????
Sent from my SM-N976B using Tapatalk
Brake discs
-
Seattle-squash
- 2nd Gear
- Posts: 182
- Joined: Sun Jun 21, 2015 5:33 pm
Re: Brake discs
Yes, thats the easiest way and no harm in the process.
Re: Brake discs
Absolutely, and give them a good wash and jet wash afterwards and your callipers as this will stop brake wobble too.
RS4 B7, Mugello Blue, K&W V3 & HR ARBs, set up by Centre Gravity, Milltek Valved Non Res & cat bypass pipes, BMC air filter, braided hoses, DOT 5.1, Terraclean, MRC Full Carbon Clean, MRC remap 448PS 477NM, 20" S7 alloys with 4mm spacers & Hawke spigots 66.6 > 57.1, AP Racing front discs. Sold Sept 2019. Now rocking an F80 M3
Re: Brake discs
Cheers. Much appreciated
Sent from my SM-N976B using Tapatalk
Sent from my SM-N976B using Tapatalk
Who is online
Users browsing this forum: No registered users and 111 guests