Much appreciate the help.

Hi Mike, I haven't tried them yet.MikeFish wrote:You tried Stoke Audi?
PM sentakoblivius wrote:hi,i have two rear disc.
i think the condition not so wrong + i have genuine pads too.
if you send me your email,then i can send some photo.
thx
Hi we can supply discs on bells for the rear @£510.00 per pairChuds1 wrote:Looking for a set for rear disc's for my RS4 B7 2006, either good condition used or best priced new.
Much appreciate the help.
Can you do them drilled like the originals?Vari Perf Brakes wrote: Hi we can supply discs on bells for the rear @£510.00 per pair
Check our FB page Vari performance brakes
Left a message on FB regarding cost of fronts and rears and quality of discs (OEM if not better?)...Vari Perf Brakes wrote:Hi we can supply discs on bells for the rear @£510.00 per pairChuds1 wrote:Looking for a set for rear disc's for my RS4 B7 2006, either good condition used or best priced new.
Much appreciate the help.
Check our FB page Vari performance brakes
Thanks for the FB reply Richard. Appreciated.daveb77 wrote:Left a message on FB regarding cost of fronts and rears and quality of discs (OEM if not better?)...Vari Perf Brakes wrote:Hi we can supply discs on bells for the rear @£510.00 per pairChuds1 wrote:Looking for a set for rear disc's for my RS4 B7 2006, either good condition used or best priced new.
Much appreciate the help.
Check our FB page Vari performance brakes
Novice question but bells easy enough to re-use with no down side? : ) (sorry)
Cheers
D
Chuds1 wrote:Ended up going for a set of these, £460 all in from Germany. Think that's a pretty good deal.![]()
http://www.ebay.co.uk/itm/111784431548? ... EBIDX%3AIT
Is there any special tooling I will need to change the disc out or is it a fairly straight forward job.
Any how to guides out there for the rears?
Thanks Sam, I have the winding tool so that's good to know. Should be straight forward, fingers crossed.Surrey Sam wrote:
You will need a caliper winding tool, so that you can wind the piston back. Other than that, it's straight forward enough.
Users browsing this forum: No registered users and 92 guests