Milltek valved exhaust

[Nickyboy]

Any news on the Millie? Is it out yet,pricing etc

I'd check their website to be honest. I'm sure they are on there for the B8 S4.

[Derbz]

There's nothing on the site regarding pricing etc so it cant have been released yet. Think they were changing a few bits on it so that must be delaying it, also read it has the oval tips which is a shame as id rather have the oem look!

[Nickyboy]

Check MRC website.

http://www.mrctuning.com/index.php?opti ... &Itemid=59

[R1NGA]

OK, will fleece up and try it soon. Startup is definitely deeper and obviously different and blipping when stationary is a constant thrill....

Vid might take a while as I have a leaking piston seal on one of the Movit calipers, so that might take a week or so to sort out. However, it will come.

Videos?

OK, these vids are a bit weak, but they do make a direct comparison from one to the other, even if one of them is at night and you can see nothing.... Each one with iPhone in same posiion pointing up at the tailpipes on one side. The night clip had a slightly more reflective surface under the car (dirt-floored carpark for the std pipes, tarmac for the APR), hence there's more engine noise. However, basic comparison remains the same I think. There's a mass of clips on YouTube for these pipes, so these were for my own benefit to see the direct before and after comparison.

Standard pipes


APR RSC


I'll not make a good film director though....

[Nickyboy]

That sounds much nicer.