Wheel Cleaning Question

[DrGold]

Just had 4 new tyres fitted; any top tips for getting rid of the old very sticky gunk where the old wheel weights were stuck on? Must needs something pretty harsh and abrasive to shift it?

[wolfgang]

Try Autoglym Engine and Machine Cleaner. I've used that to get rid of hardened tree sap on paintwork, yet the product is safe on plastics. It's a heavy duty degreaser so should be strong enough to dissolve the glue residue. Spray on liberally, leave for 5-10 minutes and then use an old towel or rag to wipe off. Repeat and then thoroughly rinse the alloy.

Your other option is to use a strong household cleaner something like Cillit Bang.

[RS-4-Me]

Autosmart Tardis is what you need. You can buy it here: http://www.polishedbliss.co.uk/acatalog ... -cat6.html

[MB2]

Some petrol or lighter filuid should also work

[DrGold]

Thanks for the suggestions - will give it a go once the weather warms up a bit!

[lengster1]

Autoglym machine cleaner doesnt touch the little tar and brake dust spots though,Autosmart tardis seems a quite strong acid based product? Whats the general opinion on this? My wheels are in for the full treatment over crimbo and i wouldnt mind buying/trying some new products,in the tardis write up it says it can eat into fresh paint,my wheels were refurbed by lepsoms in the summer will they be ok?

[lengster1]

I normally load up the areas with tar and brake spots on a few minutes before i clean them with autoglym super resin polish its softens it up nicely but is very hard work n bloody sore fingers after doing a full set,there must be an easier way?

[RS-4-Me]

I've used Tardis for a couple of yeas now with no ill effects. I don't use it every time I clean the car though maybe every six months.

Bilberry by Valet-Pro is great for wheels it's non acidic so is good for your rims. It even smells nice!

For protection I use Poorboy's Wheel Sealent then apply a coat or two of wax over the top.

[ArthurPE]

WD40 works well

[P_G]

+1 with a blunt edged spatula. Have tried tardis, AG intensive tar remover and few others and they are a faff on when the rubber and glue residue is left from old wheel weights.

[Phil3103]

Do the products mentioned here work on getting rid of (very) well established brake dust and blobs of tar too? What do you chaps use when you get the wheels off to clean them properly before applying the sealant?

[ArthurPE]

3M general purpose adhesive remover for the stubborn stuff, WD40 and Klasse all in one for the rest
I use a plastic 'scrubby', your wifey has some, lol

[MB2]

Do the products mentioned here work on getting rid of (very) well established brake dust and blobs of tar too? What do you chaps use when you get the wheels off to clean them properly before applying the sealant?

Red P21S is the best I have tried, smells like mouldy rubbish but very effective !