Is This right?

[s4-99]

I have just had a look on my car and the rivets on mine are black ( to match in with wheel arch liner i guess!) so i would presume yours have been drilled out and replaced, as they look to be in the right place.
The lower one is a torx bolt and again black in colour.

HTH

Cheers phil, thats one prob sorted then...

[s4-99]

rivets should be there

it is common for the bumpers not to align on rs4 intercooler cars becasue the ics push on hte bumper. The design of hte clip on bumper mounts is crap - you have ot use force to remove - the plastic mounts can deform over time - and hte metal part of hte wing can be adjusted if you still have the part htat bolts onto the front panel.

Nice one Doug, i dont have RS4 cooler's yet though , so i guess the mount's must be a bit dodgey. I'm not sure what you mean about the wing being adjusted and the bit that bolts onto the front panel?

[Blue_Thunder]

I'm not sure what you mean about the wing being adjusted and the bit that bolts onto the front panel?

You will do if you look at the link MCB posted in the other thread.

[s4-99]

You will do if you look at the link MCB posted in the other thread.

Nice one

[andybnwc]

Mine had no rivets arch liner seemed to cover more than that and had black torx and plastic twist clips at bottom