Anyone fitted RS4 throttle body to an S4 inlet manifold

Post by **BRETTCOLLINS** » Wed Mar 26, 2008 4:17 pm

Anyone fitted RS4 throttle body to an S4 inlet manifold?

Post by **s4woody** » Wed Mar 26, 2008 4:49 pm

your gonna need some sort of adaptor plate..IIRC the bolt holes dont line up unless the correct TB is used for the respective manifold...

Post by **dazzer** » Sun May 11, 2008 5:50 pm

BRETTCOLLINS wrote:Anyone fitted RS4 throttle body to an S4 inlet manifold?

Hi Brett,

Did you get any further looking into this?

Cheers
Daz

Post by **BRETTCOLLINS** » Mon May 12, 2008 8:42 am

For all the work needed, Didn't do it in the end. the throttle is only 4mm bigger. Anyway it is cheaper and better to go after market, but that is another story..

RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

Anyone fitted RS4 throttle body to an S4 inlet manifold

Anyone fitted RS4 throttle body to an S4 inlet manifold

RE: Anyone fitted RS4 throttle body to an S4 inlet manifold

Re: Anyone fitted RS4 throttle body to an S4 inlet manifold

RE: Re: Anyone fitted RS4 throttle body to an S4 inlet manif

Who is online