Is there anything special about the valve (only - not sensor) on these wheels? Just that I have a set of B7 wheels that are just about to be painted, which 3 of them have the original valves. They are going on a B5 car, without pressure sensor. Can I remove these valves to use regular, tyre valves, as I've only got 3 out of the 4? If so, is it an easy job...ie just pull them out?
Thanks
Replacement Alloy wheel cost
-
Virdee Autos
- Trader (Expired)
- Posts: 2546
- Joined: Sun Jun 05, 2005 6:27 pm
I think they're screwed in....i'm sure the tyre shop will be able to assist.
From what i remember the B7 valves are different to the norm, and look much smarter IMHO!
From what i remember the B7 valves are different to the norm, and look much smarter IMHO!
Virdee Autos ~ 07950-526592
Noggy Blue RS4 - 710N's | Supersprint Exhaust | RS6 Calipers/RS4 Discs | Aero Wipers | B7 rear wiper | Pioneer AVIC-F10BT | Alcantara dash | Alcantara headlining | 15mm spacers | Pentagon Tints/Supaglass | After-run mod | Carbon steering wheel | R8 engine bay caps | Brushed Alu plate plinth |
Noggy Blue RS4 - 710N's | Supersprint Exhaust | RS6 Calipers/RS4 Discs | Aero Wipers | B7 rear wiper | Pioneer AVIC-F10BT | Alcantara dash | Alcantara headlining | 15mm spacers | Pentagon Tints/Supaglass | After-run mod | Carbon steering wheel | R8 engine bay caps | Brushed Alu plate plinth |
Who is online
Users browsing this forum: No registered users and 187 guests