Engine Bay Cleaned
Engine Bay Cleaned
I was at work and the fork lift driver wanted to see the V8 in all its glory and well he called me a tramp. He them showed me his A6 engine bay and well it was clean as a whiste and he used Autoglym Vinyl and Rubber Care. I went straight to halford's and got a bottle and started cleaning. I just used a detailing brush and a wet microfiber cloth to get all the grime of. I used the oposite end thats pointy on the brush with the cloth wrapped round for the hard to get in bits and then used the Autoglym Vinyl and Rubber Care. I also did my tyres with it and its good stuff. Found out i have 4 different tyres and is a run flat and well thats another story....
Last edited by Mark Park on Thu Feb 07, 2019 9:12 pm, edited 2 times in total.
Re: Engine Bay Cleaned
I would say not bad for 129k shown you mine show me your's
Re: Engine Bay Cleaned
That looks great! Awesome job!
Re: Engine Bay Cleaned
Looks a lot better with that intake mate, bet that cost a pretty penny
Re: Engine Bay Cleaned
Mark Park well done it looks very tidy
RS4 B7, Mugello Blue, K&W V3 & HR ARBs, set up by Centre Gravity, Milltek Valved Non Res & cat bypass pipes, BMC air filter, braided hoses, DOT 5.1, Terraclean, MRC Full Carbon Clean, MRC remap 448PS 477NM, 20" S7 alloys with 4mm spacers & Hawke spigots 66.6 > 57.1, AP Racing front discs. Sold Sept 2019. Now rocking an F80 M3
Re: Engine Bay Cleaned
Looks good for 12 years old
Re: Engine Bay Cleaned
Mine cleaned few days ago with 60k on
Sent from my ONEPLUS A3003 using Tapatalk
Sent from my ONEPLUS A3003 using Tapatalk