So i had a go at changing the DRL’s as I didnt like how yellow they were.
I saw FrazerD’s build page and thought they looked much better so would give them a go.
Didn’t want to spend loads so got these £8 ones off eBay.
https://rover.ebay.com/rover/0/0/0?mpre ... 2221930595
Everything I read about doing the job said it was difficult/fiddly and you need small hands. I’m 6’6” and have large hands so i dreaded this! Turns out it’s not that bad, just had to think about the angles. The drivers side is the worst with the hoses in the way.
The before and after pics don’t look amazingly different, but it is much whiter looking at it in the flesh.
I’ll add a nighttime pic when it gets dark.
But if you’re thinking about doing it - it’s not as bad as you read!
Changed DRL’s
Re: Changed DRL’s
It looks good. well done. It brings it up date.
RS4 B7, Mugello Blue, K&W V3 & HR ARBs, set up by Centre Gravity, Milltek Valved Non Res & cat bypass pipes, BMC air filter, braided hoses, DOT 5.1, Terraclean, MRC Full Carbon Clean, MRC remap 448PS 477NM, 20" S7 alloys with 4mm spacers & Hawke spigots 66.6 > 57.1, AP Racing front discs. Sold Sept 2019. Now rocking an F80 M3
Who is online
Users browsing this forum: No registered users and 501 guests