RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

http://www.letstorquebhp.com/calculator.asp

How close is this to actual figures if you have been on a strip?

Its not too far out..

Gutted pre cats, milltek cat back MRC Remap i put 440bhp and 1620kgPower at Flywheel (BHP) : 440

Weight without Driver (KG) : 1620

Power to Weight Ratio (BHP Per Ton) : 275.97
0 - 60 (Secs) : 3.98
0 - 100 (Secs) : 9.56
60 - 100 (Secs) : 5.58
Quarter Mile (Secs) : 12.54
Terminal Speed (MPH) : 114.54
Drag Strip Quarter Mile (Secs) : 12.14
Drag Strip Terminal Speed (MPH) : 118.30

At Santa pod (after many cars had removed the super grippy coating, so cant be classed as full prepped drag strip)

Car did 12.60 @ 113mph with 2.1 sec 60ft
also did 12.82 @ 111mph with 1.9 sec 60ft and missed 3rd gear so would have been low 12's

So not too far out!

A little but not far - my figures suggests it's a little too generous...
Standard car, so...

Power at Flywheel (BHP) : 380
Weight without driver (KG) : 1620
Drive Type : 4 Wheel Drive (4WD)

Power at Flywheel (BHP) : 380
Weight without Driver (KG) : 1620
Power to Weight Ratio (BHP Per Ton) : 238.33
0 - 60 (Secs) : 4.46
0 - 100 (Secs) : 11.08
60 - 100 (Secs) : 6.61
Quarter Mile (Secs) : 13.08
Terminal Speed (MPH) : 108.68
Drag Strip Quarter Mile (Secs) : 12.68
Drag Strip Terminal Speed (MPH) : 112.17