https://youtu.be/9F2FMIzXw5M
Wait until you see the end result on the Mclaren.
HRE 3D printed Titanium wheel, what the what?
- Mr Footlong
- Cruising
- Posts: 4320
- Joined: Thu Nov 10, 2011 12:07 pm
- Location: Stalking Kate Beckinsale
HRE 3D printed Titanium wheel, what the what?
Current:
"Brutus"- C5 RS6 Avant - MRC stage 2 - Milltek non-res + 100 cell cats - Wagner ICs - PSS9 - H&R ARBs - OZ Superturismo LM - C6 Custom brakes - HD RNS-E - Various other bits - 555PS/832Nm
Gone:
"Taz"- C7 RS6 - MRC stage 2 - Milltek non-res + 100 cell cats, uprated fuel pumps, race plugs, 745PS/1095Nm
12' Cayenne Turbo, B7 RS4, S3, Cupra R, XJR, EVO VII, STI8,5,2&WRX, 106 GTI&XSI, other crap.
"Brutus"- C5 RS6 Avant - MRC stage 2 - Milltek non-res + 100 cell cats - Wagner ICs - PSS9 - H&R ARBs - OZ Superturismo LM - C6 Custom brakes - HD RNS-E - Various other bits - 555PS/832Nm
Gone:
"Taz"- C7 RS6 - MRC stage 2 - Milltek non-res + 100 cell cats, uprated fuel pumps, race plugs, 745PS/1095Nm
12' Cayenne Turbo, B7 RS4, S3, Cupra R, XJR, EVO VII, STI8,5,2&WRX, 106 GTI&XSI, other crap.
Re: HRE 3D printed Titanium wheel, what the what?
These have been discussed elsewhere. Insane wheel, probably only suits the P1. I'd hate to try and clean it...
No matter where you go, there you are.
Re: HRE 3D printed Titanium wheel, what the what?
Printed titanium wheel centre in it, I was looking forward to seeing how they print the round bit round
RS4 B7, Mugello Blue, K&W V3 & HR ARBs, set up by Centre Gravity, Milltek Valved Non Res & cat bypass pipes, BMC air filter, braided hoses, DOT 5.1, Terraclean, MRC Full Carbon Clean, MRC remap 448PS 477NM, 20" S7 alloys with 4mm spacers & Hawke spigots 66.6 > 57.1, AP Racing front discs. Sold Sept 2019. Now rocking an F80 M3
Who is online
Users browsing this forum: No registered users and 134 guests