Page 1 of 1
Spacers On Standard PE
Posted: Thu Dec 12, 2019 3:45 pm
by ShaneyB
Hi guys,
2 months of ownership and love the C7. A bit like my wife in that I love all the curves but sometimes wish it was just a tad slimmer.
So in contradiction to the above somebody has suggested putting 12mm/15mm spacers on my car but without lowering it. What do you think? Will it look a little naff?
I also have a phobia of going anywhere near width restrictions and most multi-storey car parks so I'm guessing this wouldn't be the best cheap mod.
Any thoughts/pictures appreciated.
Cheers
Re: Spacers On Standard PE
Posted: Thu Dec 12, 2019 5:35 pm
by MikeFish
I'm sure there is a thread about this already with photos.
Re: Spacers On Standard PE
Posted: Thu Dec 12, 2019 5:44 pm
by ShaneyB
Been searching and can't find anything Mike. What do you think? Look crap?
Re: Spacers On Standard PE
Posted: Fri Dec 13, 2019 7:12 am
by MikeFish
I think it'll be an improvement but lowering will look much better.
Re: Spacers On Standard PE
Posted: Fri Dec 13, 2019 9:18 am
by HDPete
And lowering is very easy if you have air suspension
Re: Spacers On Standard PE
Posted: Fri Dec 13, 2019 9:19 am
by HDPete
I had mine lowered and spaced for just a few hundred GBP
Re: Spacers On Standard PE
Posted: Fri Dec 13, 2019 9:20 am
by HDPete
Re: Spacers On Standard PE
Posted: Fri Dec 13, 2019 10:29 am
by ShaneyB
Cheers guys,
I have DRC and 285 21" tyres.
I don't want to lower it just yet so I may go to R-Tec and have a look at some on.
Thanks all.
Re: Spacers On Standard PE
Posted: Fri Dec 13, 2019 1:14 pm
by Daveperc
I put 295 section tyres on, and 5mm spacers all round (so inside of tyre is where it was, and outside is +10mm.
Stance looks great, and no rubbing. And yes on DRC, not lowered.
Dave
Re: Spacers On Standard PE
Posted: Fri Dec 13, 2019 1:16 pm
by ShaneyB
Daveperc wrote: ↑Fri Dec 13, 2019 1:14 pm
I put 295 section tyres on, and 5mm spacers all round (so inside of tyre is where it was, and outside is +10mm.
Stance looks great, and no rubbing. And yes on DRC, not lowered.
Dave
Any pics?
Re: Spacers On Standard PE
Posted: Fri Dec 13, 2019 5:30 pm
by Daveperc
Dave
Re: Spacers On Standard PE
Posted: Fri Dec 13, 2019 5:38 pm
by Weiß-sechs
Needs mud flaps
