Hi
My C7.5PE has 30% left on the fronts with some slight disc scoring. What is the recommended replacement of pad, over those offered by Audi and are there any forum partners who supply?
Thanks
Pete
Recommended pads for steel brakes
Re: Recommended pads for steel brakes
I used Ferodo DS2500 with Goodridge braided hoses with better brake fluid and thought they were better than OEM especially once they had a bit of heat in them.
Only down side was that they don't come with any wear sensors so you have to keep an eye on them and use a shorting device to stop getting an error on the dash (which is an MOT failure).
Only down side was that they don't come with any wear sensors so you have to keep an eye on them and use a shorting device to stop getting an error on the dash (which is an MOT failure).
Re: Recommended pads for steel brakes
Yep DS2500's, you will notice the difference especially when it's raining.
RS4 B7, Mugello Blue, K&W V3 & HR ARBs, set up by Centre Gravity, Milltek Valved Non Res & cat bypass pipes, BMC air filter, braided hoses, DOT 5.1, Terraclean, MRC Full Carbon Clean, MRC remap 448PS 477NM, 20" S7 alloys with 4mm spacers & Hawke spigots 66.6 > 57.1, AP Racing front discs. Sold Sept 2019. Now rocking an F80 M3
Who is online
Users browsing this forum: No registered users and 176 guests