RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

Has anyone tried products from this company?
ispiriwheels.com

A simple search of the forum will bring up hundreds of results.

I nearly bought a set but tbh found there service a bit pants. they would not commit to giving me the correct offset needed for my car and said 10" wide would fit.( have the bitdi) and if they didnt it would be my responsibility and cost to send them back.
If you already know the width and offset you need then should be fine.
Which design are you looking at?

Yep had two sets

No problems

I have already got the FFR1 in Titanium from them. 21x 10,5 ET30. Havent try them on the car yet as i put 285/30 rubber on them next week. But seems to get close to suspension. Goes in 17mm and out 5mm vs OEM. Negative scrub radius is then about -5 mm. Want to go for 5mm spacers all around. Should be Ok?

I know plenty of people that have these wheels with no issues.

No issues thus far. Just purchased wheel spacers to bring out a little though to help with placing under the arch better.

Tried them on with OEM rubber . They are very close to suspension without spacers. We are talking about 2-3 mm/ 0,1 " . Will install 5mm spacers then i can use the same wheel bolts and also improve looks.
I see some of you with 10,5x21 has 15mm/20mm spacers. Is that with 10,5 ET 30?

Two pics

First and second C7

20mm rear Spacers

15mm front Spacers

25mm drop

Perfect look
Is this 10,5" wheel with ET30 and you still go with 15/20 mm spacers?

No way those are ET30 with 15/20MM Spacers...must've been a higher offset wheel.

That would make it 10.5 +15 Front and +10 Rear. That's very aggressive.

Yes they are.

I’ve ran numerous different set ups.

Couple more