RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

So after much deliberating and wondering if I would regret the change decided it was time to make the move to the 6 can honestly say I'm not disappointed it's effortlessly fast and a nice place to be ! Blown away these pics prob not the best quality but just done on the phone can't wait to get my plate on

Stunning colour combo, looks great.

Nice... great weather for it

Looking good!

Nice side shots

Congrats on the new toy, looks great in white with the black optics.

Thanks guys it's been so bright An sunny here can't get decent pic of it ! They just don't do it justice at all needs a Zorst and al get my red calipers on asap maybe black badges loving it so much An road tax so cheap compared to the b8

Congrats.

Looks like you have the non sport exhaust. Have you looked at getting the front and centre resonators deleted rather than an aftermarket exhaust?

Not had a chance to look at anything yet Mike other than a possible milly or capristo again it's not largely specced but didn't need it to be it's got pan roof black pack rear tints and my phone says Audi wifi but didn't think it had this ??? Got set spare red calipers from my B8 so al stick them on !

Oh and the black 21s

To save you researching you can have this for about £360:

MikeFish wrote: ↑

Mon Mar 27, 2017 1:06 pm

Congrats.

Looks like you have the non sport exhaust. Have you looked at getting the front and centre resonators deleted rather than an aftermarket exhaust?

Miltek best, go for it, you won't regret

Sounds wicked mike is it just a bolt on or does existing need cut ?
Tadass does milltek drone ? This is the reason I went capristo on my B8 and being honest the milltek sounded poor compared to it don't get me wrong it's a consideration but mikes sounds wicked enough to me

Afsimba wrote: ↑

Mon Mar 27, 2017 5:06 pm

Sounds wicked mike is it just a bolt on or does existing need cut ?
Tadass does milltek drone ? This is the reason I went capristo on my B8 and being honest the milltek sounded poor compared to it don't get me wrong it's a consideration but mikes sounds wicked enough to me

It's a cut and replace job. Fairly straighforward for any exhaust fabricator like Longlife or Powerflow. Mine would have been a lot cheaper but he made up some flanges to make it easier to bolt the old bit back on if I wanted to (which was never going to happen). I also have the valves disconnected as I have no need to make it any quiter.
My exhaust started out as a sport exhaust, but looking at the parts it looks like there is only one part number for the rear part of the exhaust but 2 different numbers for the front section so I think if you chop these bits out like I did, it will sound the same as a sport exhaust with the same mod (i.e. you chop out the only bit that differentiates between the 2 systems).

Afsimba wrote: ↑

Mon Mar 27, 2017 5:06 pm

Sounds wicked mike is it just a bolt on or does existing need cut ?
Tadass does milltek drone ? This is the reason I went capristo on my B8 and being honest the milltek sounded poor compared to it don't get me wrong it's a consideration but mikes sounds wicked enough to me

No drone at all, you can keep in confort mode and you okay, by the way Miltek is best sounding exhaust for Rs6 https://youtu.be/BaMU8Ktxh6g