Protect car with 3m film

Post by **danilobandeira** » Fri Nov 06, 2015 12:46 am

Hello, anybody here use or used the 3m protection that avoid that little rocks damage the paint? Or when you open the door...

Does it work?

https://m.youtube.com/watch?v=4Gl8o95LN-E

: ImageUploadedByTapatalk1446767130.418020.jpg (18.18 KiB) Viewed 1455 times

Post by **Zeebuilder** » Fri Nov 06, 2015 7:05 am

Lol I tried to fit it but was a nightmare! Got it booked into get clear on back bumper for when dog jumps in and out. Getting it done same place who does the liveries on my vans

Post by **jonicox** » Fri Nov 06, 2015 11:57 am

I was thinking about it, but decided against after having a talk with the chap that did the new car detail for me. He said that there wasn't a 3M stencil for the RS6 front, so it would have to be adapted and with all the sharp angles and edges it would be a nightmare to fit (he is a 3M registered fitter and did loads of other cars)

Post by **HYFR** » Fri Nov 06, 2015 6:29 pm

Yes, always

Post by **RossDagley** » Sat Nov 07, 2015 3:52 pm

I had a full front kit fitted my RS4 from new (well, 300 miles old). Professional install means you can't see it from more than 10ft away, and when closer can only see it on the bonnet because there's a reduction in sharpness of reflections. You'd never know it was fitted anywhere else even on the closest inspection. Bloody awesome stuff. Avoid the cheap knockoff stuff. 3M VentureShield is the way forward.

Post by **b7rs4saloon** » Sun Nov 08, 2015 9:45 pm

I have this done on my RS6

Drayke Fields fitted it, paint protection film (PPF) as he calls it, think it's a SunTek film he uses, it's awesome

Post by **danilobandeira** » Mon Nov 09, 2015 12:33 am

Tks, i am going to do this week

Post by **koruki** » Wed Nov 11, 2015 8:51 pm

I've had it since day 1, 3M qualified technician and machine cut templates. He does P1's 918s and LaFerrari's so its definitely good enough for me. He even made these thin cuts that go on the edge of all the doors where they bang into stuff. Even did the side mirror and inlay of the door handles where your nails and rings etc put a lot of wear. added a small cut where you slide things in and out of the boot/rear bumper.

Post by **HYFR** » Wed Nov 11, 2015 9:36 pm

b7rs4saloon wrote:I have this done on my RS6

Drayke Fields fitted it, paint protection film (PPF) as he calls it, think it's a SunTek film he uses, it's awesome

+1.
Just had mine done

Post by **doodlebug** » Wed Nov 11, 2015 9:45 pm

Inside? All that piss will be very corrosive.

Post by **HYFR** » Wed Nov 11, 2015 10:14 pm

That's what the slippers are for !

RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community