Help required gloss black front bumper insert

4.0 V8 40v biturbo TFSI - 553 bhp
4.0 V8 40v biturbo TFSI - 597 bhp (Performance)
Post Reply
chrisd31
1st Gear
Posts: 83
Joined: Sun Sep 12, 2010 9:16 pm

Help required gloss black front bumper insert

Post by chrisd31 » Thu Apr 11, 2019 12:04 pm

Hi just wondering if anyone knows where I could get a new black insert for the bottom of my front bumper, mine is cracked so just trying to source second hand rather than dealer ££££££££ TIA

Chris

User avatar
MikeFish
Cruising
Posts: 14847
Joined: Tue Aug 31, 2010 9:23 pm
Location: The Middle of Somewhere

Re: Help required gloss black front bumper insert

Post by MikeFish » Thu Apr 11, 2019 12:42 pm

Probably find some on ebay.

chrisd31
1st Gear
Posts: 83
Joined: Sun Sep 12, 2010 9:16 pm

Re: Help required gloss black front bumper insert

Post by chrisd31 » Thu Apr 11, 2019 3:19 pm

Few silver ones and 1 black but it’s all scratched

B-ill
Neutral
Posts: 41
Joined: Wed Jan 24, 2018 12:31 am

Re: Help required gloss black front bumper insert

Post by B-ill » Fri Apr 12, 2019 3:45 pm

I have one, PM me or text. 07825664271

Billy

Shanghara
Neutral
Posts: 14
Joined: Tue May 01, 2018 7:19 pm

Re: Help required gloss black front bumper insert

Post by Shanghara » Wed May 15, 2019 3:04 pm

TPS sell them.

adamstocks
Neutral
Posts: 37
Joined: Wed Dec 19, 2018 1:17 pm

Re: Help required gloss black front bumper insert

Post by adamstocks » Fri May 17, 2019 10:04 am

Is this a bumper off job in order to replace this?

User avatar
MikeFish
Cruising
Posts: 14847
Joined: Tue Aug 31, 2010 9:23 pm
Location: The Middle of Somewhere

Re: Help required gloss black front bumper insert

Post by MikeFish » Sat May 18, 2019 1:02 am

adamstocks wrote:
Fri May 17, 2019 10:04 am
Is this a bumper off job in order to replace this?
If you are talking about the front splitter then no it's not a bumper off job. Just need to jack the front up a bit, remove the front undertray (screwed on but be careful as you remove it as there is a wire clipped to the front edge of the tray on both sides) , remove the radiator undertray section (just pulls off) then unscrew the splitter. Think there are a few screws from the bottom then a couple at the back of the splitter pointing towards the front of the car.

adamstocks
Neutral
Posts: 37
Joined: Wed Dec 19, 2018 1:17 pm

Re: Help required gloss black front bumper insert

Post by adamstocks » Mon May 20, 2019 8:05 am

Thanks Mike :)

Post Reply

Return to “RS6 (C7 Typ 4G) 2013-”

Who is online

Users browsing this forum: LeeRS6, morski, uplandsway and 12 guests