C6 RS6 20" Speedlines, C5 RS6 bonnet, Cupra splitter to fit C5 RS6
Posted: Mon Jun 15, 2020 3:54 pm
Time for a tidy up at home and a clear out of left-over bits from my RS6.
I have:
A set of C6 RS6 "Peelers" 20xj9.5ET36 - £700
A C5 RS6 bonnet (latch included) in mug blue - £200
A Cupra splitter to fit the C5 RS6 - £20
Tarox racing pads (brand new unused these cost me £400 new) to fit C6 RS6 Brembo calipers - £150
A 6disc changer for boot fitment - £20
A Rostech Vagcom USB VCDS cable - £100 Pending
There is other stuff but I haven't been able to remember it or not been able to dig it out yet.
The bonnet is in pretty good nick, it's got some broken paint where it's rested up against something.
The tyres on the wheelset needs shot, they're close to illegal tread depth and not the correct load rating for an RS6. Three of the wheels have some curb rash but nothing major, and the finish on the powdercoat is starting to go, they're ready for refurb'ing. Other than that they're all straight and true, no cracks.
Let me know if you have any queries.
I have:
A set of C6 RS6 "Peelers" 20xj9.5ET36 - £700
A C5 RS6 bonnet (latch included) in mug blue - £200
A Cupra splitter to fit the C5 RS6 - £20
Tarox racing pads (brand new unused these cost me £400 new) to fit C6 RS6 Brembo calipers - £150
A 6disc changer for boot fitment - £20
A Rostech Vagcom USB VCDS cable - £100 Pending
There is other stuff but I haven't been able to remember it or not been able to dig it out yet.
The bonnet is in pretty good nick, it's got some broken paint where it's rested up against something.
The tyres on the wheelset needs shot, they're close to illegal tread depth and not the correct load rating for an RS6. Three of the wheels have some curb rash but nothing major, and the finish on the powdercoat is starting to go, they're ready for refurb'ing. Other than that they're all straight and true, no cracks.
Let me know if you have any queries.
