RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

Original Audi RS4 B9 2020 Carbon Fiber Interior Trim Kit. Fit to all B9 series. A4/S4, A5/S5 Sportbacc, RS5 Sportback and RS4 Avant! Matte and Glossy Carbon Available.

Price: 1150EUR + shipping + paypal fees

Info: PM or litledevil@gmail.com

Audi RS4 Glossy Carbon Interior Trim Kit



Audi RS4 Matte Carbon Interior Trim Kit

LittleDevil wrote:Original Audi RS4 B9 2020 Carbon Fiber Interior Trim Kit. Fit to all B9 series. A4/S4, A5/S5 Sportbacc, RS5 Sportback and RS4 Avant! Matte and Glossy Carbon Available.

Price: 1150EUR + shipping + paypal fees

Info: PM or litledevil@gmail.com

How easy is it to remove the existing interior trim?
Any pictures Little Devil?

Sent from my SM-N976B using Tapatalk

It is 1h job or even less. I will make and post some pictures tomorrow.

LittleDevil wrote:It is 1h job or even less. I will make and post some pictures tomorrow.

Thank you

Sent from my SM-N976B using Tapatalk

You have also one for lhd?

Yes LHD is also available, both matte and glossy carbon.

I will post all pictures on Monday or Tuesday.

Here is picture... RHD matte and glossy carbon, LHD is the same, but I can make pictures too.

And two more RS4 B9,5 2020 matte carbon, with and without flash.

LittleDevil wrote:And two more, with and without flash.

These look very nice, trouble is they look a like a bit an ordeal to remove existing without causing damage.
Has anyone on here got any experience of removing and fitting trims?

Sent from my SM-N976B using Tapatalk

There is no more than 1 hour to replace all those trims.

Here is quick installation guide:

Tools Needed:

- Socket Screwdriver 8mm
- Torx TX20
- Trim Removal Tool

Dashpanel Small Trim:

Remove fuse panel cover on driver side.







Remove 5 screws with Socket Screwdriver 8mm.









Grab your trim where you see the arrow and pull it out gently.



Use Torx TX20 to remove switch and there are 4 clips which needs to te pressed to remove it. Now install you CF frim the same way.



Dashpanel Long Trim:

3 x Torx TX20 screws needs to be removed. Open glove box and remove then and one on the other side.









Once all 3 screws are remove you just need to pull trim out. Start on passenger side you can us trim removal took or simpy grab it and gently pull it out.



You need to remove AC unit and mileage reset switch. There are 4 x Torx screws on AC unit and numbers of tabs and two tabs on mileage reset switch. Now install you CF frim the same way.





Center Console:

Remove 1 x Torx TX20 screw on the bottom of stowage compartment under rubber...



Use trim removal tool and pull it out on one side and than on the other.









Remove two Torx TX20 screws to remove stowage compartment. Now install you CF frim the same way.



Door trims:

Only trim removal tool is needed for all 4 door. Gentyl access to the tabs behing with removal tool and that's it.







If you have any question feel free to ask.

Ales

2 x Matte Carbon and 2 x Glossy Carbon available for RHD - UK Cars.

Kind Regards

Picture from customer, took him 45min for installation...

More sets vailable for RS4 and RS5.

Best Regards

RS5 Coupe - Glossy Carbon