RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

Used
Great condition
£100

Any pictures mate?

its still on the car atm

hoping to swap out next week

Will these fit s4? Can they be used with stock system?

no idea ?

I would suspect so. You could do some research on Milltek's part numbers though Jerz and see if they are the same on the S4. Would also think you can get it to fit with the standard system too. Would just likely need to get some sleeves from an exhaust Shop which won't be much. Will make a good sifference in sand Ind on a stock exhaust though. Do it!

Having swapped from a 4.2 res Milltek to non-res many years ago, I can confirm the exhausts are different bore:

S4 = 2.25 ich
RS4 = 2.36 inch

http://www.millteksport.com/exhaust.pro ... riantid=27
http://www.millteksport.com/exhaust.pro ... iantid=194

Good skills Ian. an exhaust place would have some reducers you could use to join them though.

Thanks for the advice chaps. I will look into it.

bump

How much shipped to sweden?

Any chance this fits the standard exhaust once the original centres and cut out? Cheers