RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

Due to a change of plan, i am now selling my 19" MTM Bimotos.

They are diamond cut 5x112 ET50 19's. 1 is in good condition, 1 is fair, and 2 would benefit from refurbing - this is only my personal assessment and i am no expert so please dont flame me!

Wheels in no particular order:









Looking for £550 collected (HP10 postcode) as i know that these are pretty rare. I also will have a set of new genuine Bimoto stickers which i bought from QST as i was going to have these refurbed which will be included. You are more than welcome to arrange a courier at your own expense.

Thanks for looking.

How wide are these ones?

They are 8.5 J.

ET50 as well Ringo.

Is et50 a good thing or a bad thing with them being 8.5J......?

If ringsting is after them for his rs6 then it is a bad thing.
Are these the hard type or soft type??

Aren't these Cam's old wheels?

chunky79 wrote: Are these the hard type or soft type??

Sorry - where would i find this information?

They aren't "Cams" old wheels.

I don't think they are for me, they do a wider one with a different off set for the C5

Jamess3 wrote:

chunky79 wrote: Are these the hard type or soft type??

Sorry - where would i find this information?

They aren't "Cams" old wheels.

I believe they will have forged stamped into the back of them if they are the hard type.

el_ringo wrote:I don't think they are for me, they do a wider one with a different off set for the C5

Ok. No problems. Let me know if you change your mind.

Given that the forum member that was due to collect these on Saturday did a no show without letting me know, these are still for sale. I now have the new bimoto Stickers in hand as well.

I am open to sensible offers as expected.

In response to a couple of people that have asked if these are hard or soft, i have been an taken photographs of the rear of every spoke and so please feel free to interpret as seen fit as i have no idea how to tell: (I know some of them are obvious but just want to be 100% transparent)

ET 50
L.K. 112
8.5J x19H2
BIMOTO
VIA JMJ (the last J should be backwards!)
0010
80 with a circle round it

Please dont make me have to run the eBay gaunlet.........

Now open to sensible offers before I go and refurb them.......