19" MTM Bimoto for sale - £OFFERS

[Jamess3]

Due to a change of plan, i am now selling my 19" MTM Bimotos.

They are diamond cut 5x112 ET50 19's. 1 is in good condition, 1 is fair, and 2 would benefit from refurbing - this is only my personal assessment and i am no expert so please dont flame me!

Wheels in no particular order:









Looking for £550 collected (HP10 postcode) as i know that these are pretty rare. I also will have a set of new genuine Bimoto stickers which i bought from QST as i was going to have these refurbed which will be included. You are more than welcome to arrange a courier at your own expense.

Thanks for looking.

[el_ringo]

How wide are these ones?

[Jamess3]

They are 8.5 J.

[chunky79]

ET50 as well Ringo.

[Jamess3]

Is et50 a good thing or a bad thing with them being 8.5J......?

[chunky79]

If ringsting is after them for his rs6 then it is a bad thing.
Are these the hard type or soft type??

[bam_bam]

Aren't these Cam's old wheels?

[Jamess3]

Are these the hard type or soft type??

Sorry - where would i find this information?

They aren't "Cams" old wheels.

[el_ringo]

I don't think they are for me, they do a wider one with a different off set for the C5

[chunky79]

Are these the hard type or soft type??

Sorry - where would i find this information?

They aren't "Cams" old wheels.

I believe they will have forged stamped into the back of them if they are the hard type.

[Jamess3]

I don't think they are for me, they do a wider one with a different off set for the C5

Ok. No problems. Let me know if you change your mind.

[Jamess3]

Given that the forum member that was due to collect these on Saturday did a no show without letting me know, these are still for sale. I now have the new bimoto Stickers in hand as well.

I am open to sensible offers as expected.

[Jamess3]

In response to a couple of people that have asked if these are hard or soft, i have been an taken photographs of the rear of every spoke and so please feel free to interpret as seen fit as i have no idea how to tell: (I know some of them are obvious but just want to be 100% transparent)

ET 50
L.K. 112
8.5J x19H2
BIMOTO
VIA JMJ (the last J should be backwards!)
0010
80 with a circle round it

[Jamess3]

Please dont make me have to run the eBay gaunlet.........

[Jamess3]

Now open to sensible offers before I go and refurb them.......