Adaptive light fault after lowering

[Rs4b8AA]

These

Perfect, Thanks! - Exactly what i did order, only the front though

Was both bad for you?

[Rugslasher]

It’s probably just the front on mine but ordered both just in case

[Rs4b8AA]

It’s probably just the front on mine but ordered both just in case

I now changed my left front sensor. Level error code is gone but still adaptive fail code... I will now try to change bulbs.

[Rugslasher]

Mine still had adaptive error so deleted code & hopefully sorted

[Rs4b8AA]

Mine still had adaptive error so deleted code & hopefully sorted

Ok, but can you see if the lights are moving when you turning?
Can you believe, first when i try to mount the level sensor i cant fint the locking nut, now when i want to change the bulbes i cant open the fooocking hood! (I did loose many panels to try check the wire under the wheel but all looked good.) Now i will haft to wait to monday!

Edit: Just test drive in the dark, my adaptive does not work and i still got the error code.

[Rugslasher]

Mine has always done the up /down/left & right on startup, but tbh I think mine just needed resetting due to lowering , I just thought it was the sensor as I did a lot of hammering changing the front stub axle , if mine comes back on I’ll have to recalibration on vag when I find out the codes

[Rs4b8AA]

Mine has always done the up /down/left & right on startup, but tbh I think mine just needed resetting due to lowering , I just thought it was the sensor as I did a lot of hammering changing the front stub axle , if mine comes back on I’ll have to recalibration on vag when I find out the codes

Any progress on this?

[Rugslasher]

Yes all working as it should