RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

hello all

A good friend has just purchased a B8 RS4, with the 20" rotors. Its has DRC. He wants to lower and space the wheels. We've found that H&R do a specific spring and its looks like 10mm, is a good size spacer.

Any feedback or help on this would be greatly appreciated

Thanks

don't know anything about the lowering but ive had 10mm H&R Hub centric spacers front and back for quite a few years now on standard ride height and 20" rotors with no issues and no chips underneath of the rear door handle etc as some have complained about with 10mm spacing

That’s great, thinking he will just go,spacers now. Thanks

I have the H&R 10mm hub centric all round too. 9x20 Rotors with 265/30 Bridgestones. No catching. (see @fivetones on IG for a pic, I run relatively low and the car can be driven fully).

The lowering is via the KW HAS spring kit which is adjustable. If you're happy with DRC this, to me, if the best route to go.

Brooner wrote: ↑

Fri Nov 30, 2018 2:44 pm

don't know anything about the lowering but ive had 10mm H&R Hub centric spacers front and back for quite a few years now on standard ride height and 20" rotors with no issues and no chips underneath of the rear door handle etc as some have complained about with 10mm spacing

Any photos of this? Thinking about doing the same - stock height/10mm wheel spacers Thanks!

Have a look at my photo’s. I just put my winters on (20 Rotors and 10mm all round)

Hi - Maybe a silly question, but what do you do about locking wheel nuts when using extended nuts with spacers please? Buy longer i suppose - if they exist??
Where's a good place to buy the H&R 10mm please?

Thanks

Yup - you can get longer locking bolts