Page 1 of 1
Any chance?
Posted: Wed Apr 05, 2017 9:15 pm
by Acprc
Somebody can take a picture in the morning of the wipers parked position with the bonnet up? I have had the screen replaced and I think the right hand arm is fitted wrong. Thanks.
Re: Any chance?
Posted: Sun Apr 09, 2017 7:34 pm
by 114uyc
Here you go
Re: Any chance?
Posted: Mon Apr 10, 2017 7:14 am
by Acprc
Thanks very much, I will compare with mine. I think the right hand arm is too high as you can see it from the drivers seat in the wipers parked position. I don't remember being able to see it. Tried to adjust myself but just can't get the arm off!
Re: Any chance?
Posted: Tue Apr 11, 2017 9:57 pm
by Madelvic
You need a puller to get them off the spline, something like this:
https://www.machinemart.co.uk/p/cht427- ... m-remover/
Re: Any chance?
Posted: Wed Apr 12, 2017 6:53 am
by Acprc
Even with a puller it wont come off.....
Re: Any chance?
Posted: Tue Apr 18, 2017 3:21 pm
by geoffdunk
There are two parked positions. When driving and use the wipers they go back to an upper parked position ready for use again, if they are not used they drop back under the bonnet edge. Are they just not going back to the final position automatically. Did the fitter remove the arms when replacing the screen?
Re: Any chance?
Posted: Wed Apr 19, 2017 2:09 pm
by Acprc
Sorted now. lower position on left hand blade was too high. They were removed and have now been sorted. Just needed a puller to get them off.