RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

Anyone changed the rear pads yet i ask as i was going to grind off a lip on my rear disks
i have Vag Com and followed the instructions for there site to release the parking brake as per link
http://wiki.ross-tech.com/wiki/index.ph ... king_Brake

but when i get to the opening the rear parking brake it askes for a code of 007
but all i have is a drop down box which has several options one of which is brake liner change
which i would assume is the brake pads but when i select this and press go it comes up with an error
i will run it again to get the error
anyone had this issue with Vag Com?

any suggestions welcome

Have you watched the video to see if you've made a mistake along the way?

i get a diferant screen after basic settings will check if my Vag Com is the latest version which im sure it is

ok updated the software and went through it as directed by the video but after pressing basic settings i get this screen
not like the one shown on the video the bottom picture so i dont know where its going wrong