Rotor alloys?..specs and part number?

[RS6chris!]

Guys

Saw my first B8 in the flesh today!

Looks great.

It had the 20"rotors on it they look great close up!!!

Any one have spec?

I know there 20"

What's the width?

Offset?

And finally any one know where's there's a set for sale? Or the Audi part number?

I reckon I could have finally found the wheels!!!!!

Cheers

Chris

[MikeFish]

Aren't they the same as the RS5 ones? If so plenty available.
RS5 spec is 20x9" ET26. I can dig out part number in a bit if they are the same.

[MikeFish]

Mine are 8T0 601 025 AD.

[RS6chris!]

Thanks guys

26 offset?

So my car now is 36 offset?

So ten mill spacers all round then?

Bear in mind my OEM wheels are 9.5 wide as appear to 9 wide for the rotors?

[MikeFish]

Like I say, I don't know for a fact by they look the sae o me.
If your original wheels are 9.5 you might want a 15mm spacer to make up the difference.

RS5 wheels on my B7:

[Gumball0r]

Thanks guys

26 offset?

So my car now is 36 offset?

So ten mill spacers all round then?

Bear in mind my OEM wheels are 9.5 wide as appear to 9 wide for the rotors?

It's the other way arround, the lower the ET the futher out they sit. A 9 inch wide wheel with ET 26 will sit 4 mm. further out compared to your original RS6 wheels

[MikeFish]

Sorry, yes of course, I was trying to make an ET36 wheel into an ET26 but that's not what you were trying to do. You want to make an ET26 wheel fit onto a car that normally has ET36.