New User: Hello from Germany
- Audi-RS6-R
- 2nd Gear
- Posts: 111
- Joined: Wed Jan 20, 2016 5:01 am
- Location: Heilbronn - Germany
Re: New User: Hello from Germany
@FUBAR... no - like I said BMC filters vertically - this setup on your photo is not really goof - in my opinion...because it's just hot air there...
Re: New User: Hello from Germany
The filters are almost vertical in the pic. And yes I agree, hot air is not good at all. To me it looked like they removed the top of the airboxes to illustrate the new filter solution. It looks like the cone air filters are built into the OEM airbox.
Just trying to understand your solution thats all.
Just trying to understand your solution thats all.
08 RS6 by Reperformance, MRC MAP. 977 PS - 1320 Nm.
- Audi-RS6-R
- 2nd Gear
- Posts: 111
- Joined: Wed Jan 20, 2016 5:01 am
- Location: Heilbronn - Germany
Re: New User: Hello from Germany
On the photo I can see, that the filterbox open on the downside...
I do not use these kind of filters... I use the regular BMCs
I do not use these kind of filters... I use the regular BMCs
Re: New User: Hello from Germany
i would say from my experience of tuning other cars , not started on my 6 is in theory that would be worse in many ways , have less surface area than the standard filter , if you run with the lid on it you will get poor air flow which is a huge factor in getting more power from less boost and finally suffering from mass heat soak if its fully open , id say it would have negligible improvement over a standard filter
what needs designing is a complete carbon or coated intake to reduce air temps would be a worthwhile marginal gain
what needs designing is a complete carbon or coated intake to reduce air temps would be a worthwhile marginal gain
c6 rs6 avant- mrc stage 2 -current
bmw e61 m5 saloon
s3 8p stage 2
vw bora tdi hybrid turbo
bmw e61 m5 saloon
s3 8p stage 2
vw bora tdi hybrid turbo
Re: New User: Hello from Germany
could you get a photo of your airbox's? im very interestedAudi-RS6-R wrote:On the photo I can see, that the filterbox open on the downside...
I do not use these kind of filters... I use the regular BMCs
Your RS6 is truly stunning... gorgeous example!
2014 Mercedes E63 AMG S
Wrapped in OceanShimmerBlue | MSL Stage 2 – 736Bhp/876ibft | Weistec Downpipes | K&N Large Filters | 400mm AP Racing Fronts/DS2500 Pads | Centre delete | H&R Springs/Link bars 30mm |
Gone but not forgotten
2010 Nissan GT-R SVM 680R
2010 RS6 C6 Avant Stage 2 730/1088nm
Wrapped in OceanShimmerBlue | MSL Stage 2 – 736Bhp/876ibft | Weistec Downpipes | K&N Large Filters | 400mm AP Racing Fronts/DS2500 Pads | Centre delete | H&R Springs/Link bars 30mm |
Gone but not forgotten
2010 Nissan GT-R SVM 680R
2010 RS6 C6 Avant Stage 2 730/1088nm
Re: New User: Hello from Germany
Me too!TomRS wrote:could you get a photo of your airbox's? im very interestedAudi-RS6-R wrote:I do not use these kind of filters... I use the regular BMCs
***OLD*** Daytona C5 RS6 Avant - MRC'd - 500HP & 820NM (PistonHeads Link).
***NEW*** Daytona C6 RS6 Avant - MRC'd - 955HP & 1200NM (PistonHeads Link)
***NEW*** Daytona C6 RS6 Avant - MRC'd - 955HP & 1200NM (PistonHeads Link)
- Audi-RS6-R
- 2nd Gear
- Posts: 111
- Joined: Wed Jan 20, 2016 5:01 am
- Location: Heilbronn - Germany
Re: New User: Hello from Germany
Hey...
unfortunately I have to put the boxes out and open them to make a photo...
From upside you can't see mods - they are made inside...
I will post some photos at the next filter service (clean-up, oil)
unfortunately I have to put the boxes out and open them to make a photo...
From upside you can't see mods - they are made inside...
I will post some photos at the next filter service (clean-up, oil)
- Audi-RS6-R
- 2nd Gear
- Posts: 111
- Joined: Wed Jan 20, 2016 5:01 am
- Location: Heilbronn - Germany
Re: New User: Hello from Germany
Hi.Audi-RS6-R wrote: ↑Tue Jun 07, 2016 10:04 pmHey...
unfortunately I have to put the boxes out and open them to make a photo...
From upside you can't see mods - they are made inside...
I will post some photos at the next filter service (clean-up, oil)
Is the intake from RS Engineers? Like this?
08 RS6 by Reperformance, MRC MAP. 977 PS - 1320 Nm.
Re: New User: Hello from Germany
Oops, posted a similar picture in 2016 on this tread SorryFUBAR wrote: ↑Tue Nov 28, 2017 1:46 pmHi.Audi-RS6-R wrote: ↑Tue Jun 07, 2016 10:04 pmHey...
unfortunately I have to put the boxes out and open them to make a photo...
From upside you can't see mods - they are made inside...
I will post some photos at the next filter service (clean-up, oil)
Is the intake from RS Engineers? Like this?
08 RS6 by Reperformance, MRC MAP. 977 PS - 1320 Nm.
Re: New User: Hello from Germany
So nice car. How did you fit the new c7 gear knob ? is it hard to do
Current 2007 Black Rs4 B7,
Gone Bmw 118d, S4 b5, RS4 b5, A6 2.7t, passat cc, A4 1.8t, RS5 b5, 2012 A7, 2013 Phatom black RS6
Gone Bmw 118d, S4 b5, RS4 b5, A6 2.7t, passat cc, A4 1.8t, RS5 b5, 2012 A7, 2013 Phatom black RS6
- Audi-RS6-R
- 2nd Gear
- Posts: 111
- Joined: Wed Jan 20, 2016 5:01 am
- Location: Heilbronn - Germany
Who is online
Users browsing this forum: No registered users and 162 guests