I had a phone call from my local Audi dealer asking if I could help out.
They had a C6 in for DRC problems and on removing the banjo from the shock unit it snapped off.
I haven't seen the exact location as they sent me pictures of the bolt and their driver bought it over to me to have a look at.
Now from my understanding this is not a part that is available separately, only as part of a new shock.
They stated it is not an isolated problem.
I had a look at the bolt and it is made from a fairly soft grade of aluminium and is anodised black.
It basically sheared through the cross holes, which I am not surprised about.
I measured it up and made them a new one in 304 stainless steel.
They fitted it and reported everything was fine, they seemed very happy and more importantly their customer was happy as it saved him a few quid.
If I was to make a batch of these is there any interest or call for them?


