rear pads

5.0 V10 50v biturbo - 571 bhp
Post Reply
huntersmob
1st Gear
Posts: 73
Joined: Sun Dec 11, 2016 9:04 pm
Location: Durham

rear pads

Post by huntersmob » Fri Aug 17, 2018 4:09 pm

hello all,

does anyone know if the c6 has rear brake pads wear monitoring in the electric brake side of it, I have read that some of the audi's do.
i ask as i had the warning light on and did the fronts as they where down to the wear indicators but still the light would not go off its had new wear leads on also.

regards martin

User avatar
IanH755
Top Gear
Posts: 1540
Joined: Thu Jan 02, 2014 12:50 pm
Location: Stoke and Saudi Arabia

Re: rear pads

Post by IanH755 » Sat Aug 18, 2018 12:07 pm

The rears don't have any wear sensors, either for foot or hand brake as both use the same pad.

As for the warning light, the wiring from the engine firewall bulkhead which goes down through the wing to the arch where the removable cable you've already replaced is usually the cause if the pad is still good. I've had to have my right side loom completely replaced from the firewall all the way down to the hub to fix this on mine, although it was probably easily repairable "if" the break was obvious but with the engine fitted there's no visibility of the loom at all.
***OLD*** Daytona C5 RS6 Avant - MRC'd - 500HP & 820NM (PH Link).

***NEW*** Daytona C6 RS6 Avant - MRC'd - 907HP & 1130NM (PH Link)

Post Reply

Return to “RS6 / RS6 Plus (C6 Typ 4F) 2008-2010”

Who is online

Users browsing this forum: douglas96 and 3 guests