RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

Does anyone get this when they scan for faults.

Address 25: Immobilizer
Controller: Bit teA dre ss
Component: e 17 eingeben
No Faults Found
or DTCs not supported by controller
or a communication error occurred

I have always had the same message and was wondering if it is common or if i have a comunication problem with the controller.

I had the same code on mine and from memory it hasnt come back since i cleared it. I'll try and remember to run a scan tonight

This means that the immobiliser is not at address 25 (which was used on older cars) but at address 17, which is the instruments cluster.

HTH,

Mihnea

Simon, I get the same......

Could be something to do with the presets on the VAGCOM when picking B5 A4. I have often thought about getting it to scan every address possible.....

If I remember correctly you can "fix" that in the label file. Sure it is on the vagcom forum somewhere.