RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

After 8 looong weeks my new alloys finally arrived and fitted today... They're Avant Garde M310 which i had to have made special as they don't do these wheels for the RS4 in a 20 x 9.5 with the 5x112 fitment

Holy Mackerel that is special !!

Epic taste Sir

Sexual.

very nice indeed, what tyre sizes and offset did you go for ?

Thanks guys

slowmonkey wrote:very nice indeed, what tyre sizes and offset did you go for ?

They're 155x30x20. The offset is an ET30 but i still have the 10 / 8mm spacers fitted...

Very nice

likin them alot!

Very nice mate very mean looking rather than bling
How does it feel on 20"s the ride must be a bit harder
Can you post up a picture of your front grille - thinking of doing mine black

Teutonic Tuner wrote:likin them alot!

+1

brn7y wrote:

Teutonic Tuner wrote:likin them alot!

+1

+1. Watch out for kerbs though mate...

Looks good, nice clearance too.

Get those exhausts cleaned man!

P_G wrote:Get those exhausts cleaned man!

lol you do realise they're Black Optic tips don't you? , seriously though the whole car is filthy but thankfully doesn't show too much in the pic! We've had stupid amounts of rain these last couple of days.. good weather forecast for tomorrow so it'll be clean again soon

so, regarding flushnicity:

stock is 9.0 width, ET29
these are 9.5 width, ET30

So the wheels alone are 12.7 mm wider of which 6.35 mm is on the outside. They are ET30 so net the equivalent is a stock wheel + 5.35mm spacers. You have 8 and 10mm spacers on top of that, so your setup is the flushness of stock wheels + 13.35 mm spacers up front and 15.35 mm spacers out back, right?

Just trying to wrap my head around it. I want to put 15mm spacers on the rear end of the car as the 10mm MTM ones I have are just not enough (but they're great for the front).

sakimano wrote:so, regarding flushnicity:

stock is 9.0 width, ET29
these are 9.5 width, ET30

So the wheels alone are 12.7 mm wider of which 6.35 mm is on the outside. They are ET30 so net the equivalent is a stock wheel + 5.35mm spacers. You have 8 and 10mm spacers on top of that, so your setup is the flushness of stock wheels + 13.35 mm spacers up front and 15.35 mm spacers out back, right?

Just trying to wrap my head around it. I want to put 15mm spacers on the rear end of the car as the 10mm MTM ones I have are just not enough (but they're great for the front).

Whoops, my mistake, they're 20x9, the same width as OEM... ET30 so 1mm difference.. My OEM wheels with the 10mm spacers actually filled the arch slightly more (1mm more lol)... There was no way i could even have got another mm in my arches before, i can't see how your 10mm ones are not enough... maybe it's down to the tyres and the suspension as well (I have SS+ suspension)...