another can of worms?

Post by **spikeyoldbiker** » Fri Jun 12, 2009 11:17 pm

im booked in to run my rs on the R/R at Weston Perfomance ( www.westonperformance.com )on monday the plan is to get a base line readout and then to decide what route would be best to take ..if at all

i will post the results asap after the run

Post by **ArthurPE** » Sat Jun 13, 2009 4:15 am

post wheel HP AND torque, uncorrected
use 4th gear

Post by **P_G** » Sat Jun 13, 2009 6:44 pm

We'll do the same next Saturday with 3rd and 4 gear runs hopefully

Post by **sonny** » Sat Jun 13, 2009 8:55 pm

here we go again lol....looks like I willhave to book a session at SRR whn I get my new remap done lol bunch of dyno whores we are lol

Post by **spikeyoldbiker** » Sun Jun 14, 2009 10:30 pm

lol , i missed out on the 18th/4 r/r day because of reasons beyond my control (another story!) so im looking forward to adding my pennyworth
im hoping for more than 365bhp .
After a long conversation with Doug at MRC www.mrctuning.com im taking my car to Paul Weston www.westontuning.com for a power run . i have been closely following a number of treads on this forum and i've decided to bite the bullet as it were ,if its above my hoped figure the plan would be ...MRC clean up (and mod),fcustom remap ,intake ,miltek,shortshifter,poss clutch upgrade ,ARbars ,coil overs, a few cosmetic and ICE mods if not then i will have to think about replacing my much loved rs4 , tis a matter of cash invested v returns ,i'm sure other owners that demand the most from their cars have already or will face this dilema ...but we will see
roll on tomorrow (excuse the pun)
ps to cap it off im test driving a r8 in the morning before i go ..lol

Post by **max_b** » Mon Jun 15, 2009 12:31 am

what time are you going to be there?
if any of my meetings tmoro cancel, I might try and get there

Post by **spikeyoldbiker** » Mon Jun 15, 2009 12:42 am

max b im booked in for 4pm ,would be good if you can make it

Paul

Post by **spikeyoldbiker** » Mon Jun 15, 2009 12:47 am

ps as far as i know my car is running 0090 sw and has no mods except the stone chips

Post by **dest** » Mon Jun 15, 2009 8:14 am

How much is a power run at Western these days? Last time I went it was about 90 quid!

I want to get my S2 done again, but am not paying that price lol, wish there was somewhere else in or around Northamptonshire

Post by **spikeyoldbiker** » Mon Jun 15, 2009 9:28 am

£75 plus vat ...weston is local to me so makes it cost effective

Post by **P_G** » Mon Jun 15, 2009 9:35 am

dest wrote:How much is a power run at Western these days? Last time I went it was about 90 quid!
I want to get my S2 done again, but am not paying that price lol, wish there was somewhere else in or around Northamptonshire

Is LSV at Wellingborough / Silverstone not close to you or are you on the other side of Northampton? They have a sealed cell Dyno Dynamics rolling road. Website is www.lsvuk.com, it says they are in Wellingbrorough which would be hamdy for you but they also have Unit 10 at Silverstone which is where their r/r is and it used to be WRC Technologies / Race Solutions. Chris Davies who runs the branch is very knowledgeable on r/r's

Post by **dest** » Mon Jun 15, 2009 10:26 am

Wellingborough is 15 mins from me, is it 4x4?
Sorry for the thread highjack!

Post by **P_G** » Mon Jun 15, 2009 10:54 am

Not sure about the one at Wellinborough, the one at Silverstone is and 4000 bhp rated

Post by **max_b** » Mon Jun 15, 2009 8:18 pm

sorry mate, didnt end up finishing till 6

how did you get on? how many horses are in your beastie??

Post by **spikeyoldbiker** » Mon Jun 15, 2009 9:56 pm

max_b wrote:sorry mate, didnt end up finishing till 6

how did you get on? how many horses are in your beastie??

no stress max b

338.4 bhp

i will hopefully post a scan of my printout tomorrow

the runs were done in fourth
im not suprised at the readout but disapointed

RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

another can of worms?

another can of worms?

RE: another can of worms?

Who is online