RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

is this the write power figuares or have i been coned by mapper????

spec standered car with foam uprated panel filter and remap by south west tunners...

miles 42000 miles
intake temp 15 deg c
lb per foot 293.1

all figuares rolling road dyno at power station in tewkesbury today.

help please !!!!!

Here we go...

Some B7's have dynoed as low as 360hp at the crank.

You should have ~310hp at the wheels.

Using the right fuel will make a huge difference.

Torque should be in the region of ~310ftlbs.

FWIW.

i had v power and i never run anthing else. is that power fig with remap???

Sounds like the old debate on "how accurate are the power/torque figures on a wheel dyno" all over again!

What were the before and after figures for power & torque? - that's the only "like for like" comparison you can get, and which will tell you if the re-map was worth paying for.