Page 1 of 2
MTM Bimotos titan/silver
Posted: Fri Mar 14, 2008 11:16 am
by Tilly
I'm struggling to find any pictures of a B7 RS4 saloon with these particular wheels on, I'm looking for pictures specifically in this finish:
And does anyone know how they compare weight-wise to OEM rims? I've tried searching the forum but not found much
Posted: Fri Mar 14, 2008 11:52 am
by P_G
I know someone with an RS6 with those wheels on, they look the muts..... but they are v.pricey.
Posted: Fri Mar 14, 2008 12:14 pm
by Tilly
You see I didn't think they looked too pricey... I've not got my car yet so I cant check tyre sizes etc so I don't know what they run as standard. From memory they were just over 2000 euros for the wheels alone which for forged rims I thought wasn't too bad and providing the rim width is the same as OEM I'd swap tyres from the standard wheels to the bimotos to save a few quid until they were due a change
Posted: Fri Mar 14, 2008 12:33 pm
by Tilly
are the standard OEM wheels 8.5J, 19 inch with an ET35 offset and PCD of 5 x 112?
Posted: Fri Mar 14, 2008 1:35 pm
by klauster
www.qstuning.com supplies them for something like £300+VAT per corner + tyres
Posted: Fri Mar 14, 2008 2:19 pm
by P_G
They've come down in price then, just been quoted for normal MTM Bimotos 9.5Jx19 including tyres for just over £2K.
Posted: Fri Mar 14, 2008 2:23 pm
by hugy
I have a set of MTM bimotos on my car.19x9.5" and 275/30 tyres.My wheels are anthracite finish.
Posted: Fri Mar 14, 2008 2:32 pm
by GardinerG
The irony is that they are cheaper than Audi OEM rims, for the RS6 at least.
Posted: Fri Mar 14, 2008 3:40 pm
by P_G
When I first looked at MTM's for my S4 a couple of years ago they were nearer £3k for the same size including tyres.
That's why I went for Sportecs
Posted: Fri Mar 14, 2008 9:13 pm
by 414BHP
Tilly
Check this -
http://www.pistonheads.com/sales/338498.htm
The alloys look pretty good eh!
Posted: Sat Mar 15, 2008 12:47 am
by S25MRS
Looks good, but £6k for milltek, remap and wheels/tyres?? flipping heck! Stick with my B5 I think - lol
Posted: Sat Mar 15, 2008 1:02 am
by Dom81
A bit OT, but those buckets aren't holding up very well. 6K, and serious arse marks!
Posted: Sat Mar 15, 2008 7:13 pm
by EuroSag
Must be a big lad!
Posted: Sat Mar 15, 2008 8:26 pm
by philipwalker
Check the weight of these out. They are a very heavy rim for the cost.
Better aiming for a iro 10kgs say a BBS LM 9.5x19
Posted: Sat Mar 15, 2008 8:42 pm
by EuroSag
philipwalker wrote:Check the weight of these out. They are a very heavy rim for the cost.
Better aiming for a iro 10kgs say a BBS LM 9.5x19
I'd quite fancy some BBS CH Black Edition's. What sort of weight would they be in that size?