RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

afternoon all .

I after bit of help and advice!
After a wiring diagram or a solution .

So far ,
Parking sensors not working, fuse ok 10amp . Rear sensors I can hear clicking from each one , fronts not .
So Front bumper off , changed all sensors.
And Still no joy . Also no dc from any pins from front connect plug .

So not sure if this runs through a relay ??
Any help or ideas
Thanks In Advance Barry

Baz! You’re alive! How’s life with sprog treating you?

I can’t help at all with your issue - sorry...


Sent from my iPhone using Tapatalk

Have you checked the dash switch that turns them on and off?

FaisalJ wrote:Baz! You’re alive! How’s life with sprog treating you?

I can’t help at all with your issue - sorry...


Sent from my iPhone using Tapatalk

Haha yes . I’m hanging in there ! , little monkey just turned 2 !
Hope your all well and safe

Bill'sRS4 wrote:Have you checked the dash switch that turns them on and off?

Nope not yet Bill , I check that one out over the weekend

Thanks

Bill'sRS4 wrote:Have you checked the dash switch that turns them on and off?

Only got round to check the switch all is working ok .

Bit stumped may have to book this in for a Indy !

have you checked the connector you have to disconnect to remove the bumper?
There's 3, one will be for the sensors - probably the biggest of the connectors.
The other 2 will be fog lights and air temp sensor.

Mike

mikep99 wrote:have you checked the connector you have to disconnect to remove the bumper?
There's 3, one will be for the sensors - probably the biggest of the connectors.
The other 2 will be fog lights and air temp sensor.

Mike

Yep bumpers is off , lying in front on car Nothing from the plug from main loom . I would of though I get at least 6-12 v dc ?

sorry, just noticed you put that in your first post.
The bumper's off mine at the mo so I'll check for voltage tomorrow if I remember.

Have you checked the connector into the PDC controller? behind the left hand side boot trim?

Have you scanned it at all? What does it say?

mikep99 wrote:sorry, just noticed you put that in your first post.
The bumper's off mine at the mo so I'll check for voltage tomorrow if I remember.

Have you checked the connector into the PDC controller? behind the left hand side boot trim?

Thanks for quick reply Mike

Sorry PDC ?
I think I know where u mean . Nope I haven’t checked there on it Now .

Parking Distance Control = PDC = parking sensors

I’ve just changed the PDC module , still same error !
Stumped now .
Do you think this runs through any relays ?