Front brake fitting kit
Front brake fitting kit
Is there a source for brembo retaining pins, spring clips and the plates the pads sit on other than TPS/Audi?
Re: Front brake fitting kit
I got mines on ebay for 28 quid a while back
B7 saloon, koni Shocks and h and r springs, h and r spacers 8mm f+r, milltek non res with valves, milltek d/ps, k and n filter, full mrc carbon clean, mrc stage 2 with l/c and f/s 456bhp 522nm.
Re: Front brake fitting kit
The plates the pads slide on that are held on with three screws each aren’t available separately, they are stainless so should clean up, one of mine was damaged and I had to pay £100 for one
2007 B7 RS4 Saloon, Phantom Black, Forge Oil Cooler Kit, custom home made air feed, H&R Coilovers, H&R anti roll bars, 10mm H&R Spacers, Milltek decat downpipes, Milltek Non Res Valved Exhaust, Reyland Motorsports front & rear discs with Hel braided Hoses, full underbody overhauled inc powdercoated subframes and arms, 034 solid subframe bushes and every joint, arm or bush replaced.
Re: Front brake fitting kit
I’ll have a look, cheers Quango86.
Saw those on the diagrams James1084 and not available separately
Did the screws put up much of a fight and did you manage to reuse them?
Saw those on the diagrams James1084 and not available separately
Did the screws put up much of a fight and did you manage to reuse them?
Re: Front brake fitting kit
I ended up getting the calipers refurbed so screws were OK. Just make sure once you fit the brakes you bed them in properly
B7 saloon, koni Shocks and h and r springs, h and r spacers 8mm f+r, milltek non res with valves, milltek d/ps, k and n filter, full mrc carbon clean, mrc stage 2 with l/c and f/s 456bhp 522nm.
Re: Front brake fitting kit
I used new screws as the old ones needed torx bits driving in to get them out
2007 B7 RS4 Saloon, Phantom Black, Forge Oil Cooler Kit, custom home made air feed, H&R Coilovers, H&R anti roll bars, 10mm H&R Spacers, Milltek decat downpipes, Milltek Non Res Valved Exhaust, Reyland Motorsports front & rear discs with Hel braided Hoses, full underbody overhauled inc powdercoated subframes and arms, 034 solid subframe bushes and every joint, arm or bush replaced.
Re: Front brake fitting kit
Don’t suppose you remember the specs of them or where you got them from?
Re: Front brake fitting kit
M5x10 button heads
2007 B7 RS4 Saloon, Phantom Black, Forge Oil Cooler Kit, custom home made air feed, H&R Coilovers, H&R anti roll bars, 10mm H&R Spacers, Milltek decat downpipes, Milltek Non Res Valved Exhaust, Reyland Motorsports front & rear discs with Hel braided Hoses, full underbody overhauled inc powdercoated subframes and arms, 034 solid subframe bushes and every joint, arm or bush replaced.
Who is online
Users browsing this forum: nickwigan and 222 guests