What wheels ?? Pics pics pics

[MrRSB7]

Has anybody successfully mounted 21’s or 20’s to the B7 RS4 without spacers and mods etc



If so, please post pics, or wheel models

Looking for inspiration ha ha

[ArthurPE]

My 2 cents, worth even less
Wheels plus tires = big $$$ plus long term delta tire cost 19 vs 20 or 21, and ride quality impact

Get proper spacers
H&R springs and keep drc, f -20 mm, rear -15 mm
Get oem wheels refurbished if necessary

Imo that setup looks really good

If you go with new wheels buy good quality and without lowering you may not be fully satisfied

[MikeFish]

Has anybody successfully mounted 21’s or 20’s to the B7 RS4 without spacers and mods etc



If so, please post pics, or wheel models

Looking for inspiration ha ha

I've mounted 20" RS5 wheels with no spacers. Sure you've seen photos of this set up before but if not I'll post some later.

Others have fitted 20" C7 RS6 wheels but think they need spacers.

Others have fitted same design, width and offset as oem wheels but the 20" version with and without spacers.

Don't think I've seen any 21s though. Or maybe there was one car that had them and looked over wheeled.

[Ian_C]

Don't think I've seen any 21s though. Or maybe there was one car that had them and looked over wheeled.

Stop press. It has finally happened. Mike has admitted a car has wheels that are too big.

Hell freezes.jpg (7.41 KiB) Viewed 2294 times

[Covkiller]

See my thread for details, 4mm spacers

My generic RS4 photo

[marc1]

Love your car Cov!

[MrRSB7]

I’ve found some genuine Audi wheels

Do you think they’ll fit

20x9.5
et21
5x112

Tyres are all audi rs R01 specific 275 35 20 pirelli p zero.
2 with 7mm
2 with 5mm

[Daytona]

To fit those you’re going to need tyres, spacers and probably spigot rings

[MikeFish]

I’ve found some genuine Audi wheels

Do you think they’ll fit

20x9.5
et21
5x112

Tyres are all audi rs R01 specific 275 35 20 pirelli p zero.
2 with 7mm
2 with 5mm

I did mention these wheels in my response above. But Daytona is right you will also need spigot rings and probably tyres too.

[MikeFish]

Courtesy of benhol and softishman.

[MrRSB7]

Nice nice nice!!

what tyres should I be getting size etc?

And the spacers and rings a specific size?

[Daytona]

255 30 20

[MikeFish]

Spigots should be 57.1 to 66.6.

Not sure on spacers. Depends how low you see but best to speak to one of the guys that has done it already.

[MrRSB7]

Yes.... so settled on these puppies


Bit of s snug fit, but they look dreamy

[MikeFish]

It's snug because you have much wider tyres. Those are 275 wide rather than 255 wide.