Sai removal
Sai removal
For those that have removed your secondary air injection, how did you do it? So far i have removed the pump and the two pipes that go to the airbox and the side of the engine above the exhaust manifold, trimmed the pump bracket so that it only holds the flap solenoid (which is blanked off) Will i need to blank off the vacuum lines to the valves on the back of the heads?
2007 B7 RS4 Saloon, Phantom Black, Forge Oil Cooler Kit, custom home made air feed, H&R Coilovers, H&R anti roll bars, 10mm H&R Spacers, Milltek decat downpipes, Milltek Non Res Valved Exhaust, Reyland Motorsports front & rear discs with Hel braided Hoses, full underbody overhauled inc powdercoated subframes and arms, 034 solid subframe bushes and every joint, arm or bush replaced.
Re: Sai removal
Yes dont leave any vac lines open
Current-saloon rs4,Full decat Xpipe miltek,cold air feed,BMC air filter, TTS supercharged, MRC stage 3 L/C F/S,hell s+s brake lines,AP racing rotors + vagbremtechnic bells, kw v3s clifford 650mk2
Gone-audi s3 8p stage2+ with loba lo400 turbo.
Gone-audi s3 8p stage2+ with loba lo400 turbo.
Re: Sai removal
Bought some aluminum plates to fully remove the valves now, i will have the inlet manifold off soon so will do it then.
2007 B7 RS4 Saloon, Phantom Black, Forge Oil Cooler Kit, custom home made air feed, H&R Coilovers, H&R anti roll bars, 10mm H&R Spacers, Milltek decat downpipes, Milltek Non Res Valved Exhaust, Reyland Motorsports front & rear discs with Hel braided Hoses, full underbody overhauled inc powdercoated subframes and arms, 034 solid subframe bushes and every joint, arm or bush replaced.
Who is online
Users browsing this forum: No registered users and 221 guests