RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

Someone managed to rip my OSF fog light grille out in a supermarket car park. I found it lying by the car. Fortunately no other damage, however all the tabs had broken off so I picked up a replacement today.

Is there a knack to fitting it I should be aware of? Inside/outside/top/bottom first etc. Or line it up square and whack it with a "persuader"? I don't want to break any tabs off by fitting it arse backwards and having to remove/replace.

My Google-foo is deserting me on this.

Ta!

There is a stick out tab I think on the end towards the centre of the car so that side goes in first then push the rest on. I'll have a look through old photos to try and work it out. But it is defo either left of right side first then push in.

DuncanF wrote:Someone managed to rip my OSF fog light grille out in a supermarket car park. I found it lying by the car. Fortunately no other damage, however all the tabs had broken off so I picked up a replacement today.

Is there a knack to fitting it I should be aware of? Inside/outside/top/bottom first etc. Or line it up square and whack it with a "persuader"? I don't want to break any tabs off by fitting it arse backwards and having to remove/replace.

My Google-foo is deserting me on this.

Ta!

Outside edge goes in first, then it clips in moving towards the middle of the at.


Sent from my iPhone using Tapatalk