Removal of 4 Ring badge

[Firestarter]

Hi Guys

Anyone know how to remove the 4 ring badge on the front grille? I have a Black badge I want to fit and before I start prodding about wanted some advice.

Thanks chaps

[HYFR]

Just pull it out.
Clips on the badge itself will snap but no avoiding that even if uber careful

[MikeFish]

To remove it properly you need to release the little plastic catches at the back which means removing the bumper. However, this is a waste of time, as DK says, pull the thing off. If you need to use it again, buy a new one. You can release a few of the catches from the front if you are a little nifty but ultimately you are bound to break a few; you can see the position of the catches from your new badge.

[Firestarter]

Thanks Guys

All done and I just used a small flathead screwdriver to release it. Black looks soooooo much better!!!!

[MikeFish]

You knows it!

[Madmonkee]

Let us see then!

[MikeFish]

You can have a pic of mine while you wait for Louie, he could be a while

[KikapuRS]

Lookin good

[Firestarter]

Here ya go

[Madmonkee]

Mmmm might make a purchase

[MikeFish]

You can have a pic of mine while you wait for Louie, he could be a while

I was right!

I don't like the black rear badges, but they are much better than the shiney silver ones. I just left mine off instead.

[Madmonkee]

Matt or gloss? I was thinking about black RS4 also

[sakimano]

I like black rear but normal front. I have an Avus car.

I think you need the rings to contrast and standout. Black on black they just kinda disappear.

[MikeFish]

I wanted mine to disappear, hence black on the front (couldn't get rid of it altogether as it's mounting bracket would stil be there) and none on the rear.

[RIV]

I wanted mine to disappear, hence black on the front (couldn't get rid of it altogether as it's mounting bracket would stil be there) and none on the rear.

I like idea of black on the front with no rings on the rear,lets see a pic of the rear please mike