RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

Looking at a set of wheels and wondered if these would fit.

19"x8", 5x112, centre bore 66.6mm and ET27.

Many Thanks

I think you'll need a spigot ring to take the bore down to 57.1, but should fit otherwise. Don't think the offset is too low, but not 100% up to speed on the best fitment for our cars.

joesnow wrote:Looking at a set of wheels and wondered if these would fit.

19"x8", 5x112, centre bore 66.6mm and ET27.

Many Thanks

In addition to the advice above check the front caliper space.

I doubt it would work, would be better with an 8.5jx19 wheel with that ET to clear the front calipers unless you also use min. 10mm spacers with your 8J wheel.