My B6 Supercharged Stage 1+ RS4 build thread...

[J130YCE]

Im running 620...

[iconic78]

Im running 620...

You should be able to push that higher by lowering your IAT’s.

Have you run any logs?


Sent from my iPhone using Tapatalk

[J130YCE]

No, but its at MRC as i write.... now is the time!?

[iconic78]

No, but its at MRC as i write.... now is the time!?

You can run logs anytime through VCDS and a. Ross tech cable.

I would suggest you dyno the car before and after, as most SC tunes run rich(for safety). Running lower IAT’s allows you dial back on the timing and mixture therefore making it more efficient and producing more power.

Did you get my messages?



Sent from my iPhone using Tapatalk

[J130YCE]

Yes, thanks, I have emailed Joe.

Thanks very much for the information

[m2motortechnik]

So after a long and very hot summer(62c was the hottest) now finishing everything off on the car before we move countries. The car of course is coming with.

Ok so had it Dyno’d at 670ps and now I’m uprating the LPFP to a 340 LPH in anticipation of having a built engine to have a crack at getting close to the magic 800!
I’ve already previously replaced the HPFP’s for uprated units.
Will be reflashing the ecu again. Also fitting a Killer Chiller to reduce IAT’s.

The remaining bodywork will be completed before the end of the month. As that’s when the car is being shipped.


Sent from my iPhone using Tapatalk

where is the dyno print out ?can you post it ?