DRL Lights..

Post by **MarkMRS4** » Tue May 10, 2011 1:04 am

Whats the best bulbs for these, as mine look yellow and i would prefer a more white light...

any suggestions?

Thanks
Mark

Post by **alex020869** » Tue May 10, 2011 5:05 am

I have just put LED bulbs and resistors in mine. Look loads better. Not a difficult job.

Alex

Post by **MB2** » Tue May 10, 2011 9:15 am

I bought the PIAA incandescant bulbs - pretty sure are these H36 S25 27W SINGLE FILAMENT BAYONET They aren't E Marked as look a little blue when off but look a good match when on + no resistors to splice in.

Post by **P_G** » Tue May 10, 2011 9:31 am

+1 IIRC someone has / had a set for sale in the Classifieds.....

Post by **MarkMRS4** » Tue May 10, 2011 1:14 pm

So what is the code for the bulbs am looking for then?

Just wanting rid of the horrible yellow, nothing pure bright and looks like av drove through the ripspeed isle at halfords!

Post by **MB2** » Tue May 10, 2011 1:25 pm

If you want PIAA it is H367

Post by **MarkMRS4** » Tue May 10, 2011 1:39 pm

You have a picture of these when on?

There a set on ebay for £30!

Post by **RS6chris!** » Tue May 10, 2011 3:48 pm

MB2 wrote:If you want PIAA it is H367

Correctomondo....ive someof these look just as good when off...as mentioned above slight blue tinge among the mirror finish...but when on they look good.

HOWEVER...They seem to knock out some serious heatand my bulb holder is slightly brown and burnt looking...

Also i think the heat has affected the bulb because the small contact on base of bulb is starting to crumble....kept getting a bulb out warning but when i check its the fit of the bulb in the holder..a quick wiggle about and its back on..

Post by **P_G** » Tue May 10, 2011 5:32 pm

MarkMRS4 wrote:You have a picture of these when on?

Try this link http://forum.rs246.com/viewtopic.php?f= ... AA#p357344

or this....

Post by **scaghead** » Tue May 10, 2011 7:12 pm

i have had the piaa bulbs now for 18 months and had no issues with them..well worth getting imo..saves all the poncing about with resistors. had to go the resistor route on my number plate leds..

Post by **MB2** » Tue May 10, 2011 8:29 pm

Must say mine have been no problem either although I do remember someone saying on here they can overheat as I looked at reducing the output in VCDS but whatever I set them to seemed to make no difference to my eyes !

Post by **P_G** » Tue May 10, 2011 8:58 pm

No issues with mine either in 2 years of ownership

Post by **MarkMRS4** » Tue May 10, 2011 10:04 pm

Thanks for all the feed back! They look a million times better!

So wheres best to grab a set then?... Links appreciated

A take it the led reg bulbs are a hassell?

Post by **andre3k** » Tue May 10, 2011 10:17 pm

I don't think all reg LED lights throw an error. The dectane ones appear to be fine (don't have them on my car, but they have a YouTube 'how to' vid and all seems fine on it)

eBay for the PIAA's. You can get them for about £26 if you search thoroughly if I remember correctly.

Post by **MB2** » Wed May 11, 2011 10:44 am

Our cars have a problem with all the LED numberplate lights due to the colour DIS - they seem to have been tested on the red DIS & then inferred they will work on all A4 variations... Have tried the "modules" & the "canbus safe" festoon lights & neither worked...

RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

DRL Lights..

DRL Lights..

Re: DRL Lights..

Re: DRL Lights..

Re: DRL Lights..

Re: DRL Lights..

Re: DRL Lights..

Re: DRL Lights..

Re: DRL Lights..

Re: DRL Lights..

Re: DRL Lights..

Re: DRL Lights..

Re: DRL Lights..

Re: DRL Lights..

Re: DRL Lights..

Re: DRL Lights..

Who is online