Page 1 of 1

Fitted Milltek!!

Posted: Fri May 18, 2007 9:37 am
by BlackS3
Had Jabbasport fit a Milltek exhaust to my S3 last week and it's awesome. It took a couple of days to settle in now it sounds amazing!

I really wanted a sports exhaust but didn't want the loud drone u get on the motorways when cruising so opted on the Milltek over the supersprint. It's quiet when driven at a relaxed pace which is perfect and when u open up the throttle it has a throaty roar to it. Also when u rev the engine it pops beautifully as the revs come down. U can even hear it pop changing up gears at times.

So if u want performance but without the earache choose Milltek :wink:

Re: Fitted Milltek!!

Posted: Sun May 27, 2007 9:49 pm
by s300tna
BlackS3 wrote: So if u want performance choose Milltek :wink:
Er not sure about that part! dont think you will get much if any just fitting cat back. 4/5 horse power maybe

RE: Re: Fitted Milltek!!

Posted: Mon May 28, 2007 1:17 pm
by BlackS3
I meant as in performance exhaust systems. If u just wanted performance you could fit a NOS kit?

I'm aware i could fit 200 cell cats manifold and down pipe if it was all about perfomance but then i'd want the bigger turbo, injectors, FMIC, etc.....

Besides there is a lot more to performance than just one item

RE: Re: Fitted Milltek!!

Posted: Tue May 29, 2007 11:57 pm
by BlackS3
And besides u edited my quote

I said without the earache, specifically meaning that Milltek pride themselves on being about performance but without too much noise