Dealer me and 1.6mm tyres
Posted: Fri Jul 21, 2006 12:59 am
guys picked up my 55 plate 14/7 from Camerons Perth (exemplary service) !!! parked on hard lock today 21/7 noticed inside of front tyres scrubbed. Only done around 400 easy miles since picked up. rear tyres 4mm so they look fine....
Dived into local Kwik Fit and had checked, both insides down to less than 1.6mm, crown and outsides barely 3mm. Reading Audi literature, the min for an approved Audi should be 3mm. raised question with Sales guy who sort of tried to pap me off with the MOT standard comments etc...
The question is, is the 3mm over the whole tyre or is it just over 3/4 of the tread, a la MOT/Police standards
anyone know what the correct interpretation of the Audi approved 3mm rule is.
Ill keep you informed , as i have asked for them to be replaced, hopefully they will as i have had outstanding service so far...
any comments at all would be great
regards yer pal stuart
Dived into local Kwik Fit and had checked, both insides down to less than 1.6mm, crown and outsides barely 3mm. Reading Audi literature, the min for an approved Audi should be 3mm. raised question with Sales guy who sort of tried to pap me off with the MOT standard comments etc...
The question is, is the 3mm over the whole tyre or is it just over 3/4 of the tread, a la MOT/Police standards
anyone know what the correct interpretation of the Audi approved 3mm rule is.
Ill keep you informed , as i have asked for them to be replaced, hopefully they will as i have had outstanding service so far...
any comments at all would be great
regards yer pal stuart