RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

Hi,

Does anybody know of/recommend anywhere to get my 1999.5 S4 4 - wheel aligment done in the Kent area apart from going to the main dealers? Only place I know of is Elite in Essex but that is a bit of a trip and I am hoping there is somewhere a bit closer?

Also I have 18" RS4 replicas on my car and 10mm spacers on the front (to clear the cailpers). Does this mean that I cannot be set up to the Audi standard settings? Currently my fronts are wearing on the outside edge and the rears on the inside edge

Thanks
Brad

hello brad the only other place i know of is amd essex it is a little bit nearer than elite

Thanks Dave. I emailed AMD last week for a quote and not had a reply yet? I think I will ring them tomorrow. Does anbody know if they supply/fit tyres as well?

Assume that AMD are well recommended on here?

Thanks
Brad

You could also try Bexley Motor Works, in Bexleyheath.

They have the Hunter Pro 4WLA machine there, they specialise in race prepping BMWS so they have the noggin to do a good job. I have not yet tried them, but have my RS4 booked into them in 2 weeks. I have used them before when I owned a BMW, I have confidence to let them near the Audi

Thanks Sonny.

Got it booked in now to AMD on Saturday. Heard a lot of good reports about them.

Thanks
Brad

Top job done by AMD on Sat. All done for a very resonable price.

Out of interest I am running toyos at the moment on 18" rims (235/40/18). Anybody running the same on their S4 then what tyre pressures are you running? I am running 38 psi all round but not sure if this is correct?

Cheers
Brad