RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

I have just managed to get my hands on an RS4 Front bumper. What is required to get it to fit my S4? Any help would be appreciated.
Thanks

The sides are too wide, you have tho "shrink" those somehow.

Also the bumper supports have to be little longer.

Here is my version of it http://valitalo.org/rs4_bumper.htm

Nice job okkim .....is that a metal support fabricated to replace that nasty formed plastic support...... or is it decieving and that is the plastic piece re-formed ....
on moulding it - I started to do mine in a very similiar way, about 2yrs ago ..... rain come - sat in the shed since ..... one day it will get fitted ..

That metal support is there for supporting the bumper to be in right formation. The plastic was also heated and molded. Then the metal support was glued to the bumper.

I just wanted to be sure that it won't change it's shape in the sun or cold. And it didn't even when I cracked the whole bumper in the accident! Those were the only survived parts

bummer what a shame, i feel for you bud

CliveH has done this I believe. Might be worth PM'ing him.

I've got a feeling Clive's was fitted without having to be reshaped as such, think the brackets held his in flush with the arches.

okkim wrote:That metal support is there for supporting the bumper to be in right formation. The plastic was also heated and molded. Then the metal support was glued to the bumper.

Was it 15mm sq. tube ...? looks good... already started forming with heat and cuts .... but a loooong time ago ...

nicely reshaped by the way ... care to enlighten us ... walked away from it ok ..?

So do u need to extend the bumper supports?

h8cak wrote:So do u need to extend the bumper supports?

You can bodge it by packing out the s4 units .... I got proper ones for the job though .... u need about 15mm extension .... i think ...?

S4TAN had his done by Greg Howell at Southam Bodies....great job too

So can i just buy some Rs4 supports? Are they a direct swap?

Yes you can swap to the RS4 supports, no problem.

nicely reshaped by the way ... care to enlighten us ... walked away from it ok ..?

Yes I didn't got a single scratch, but almost drowned...! Those are safe cars... My widebody project started there.

when we did Clives we used the RS4 mounts and packed them slightly at the top to angle them a bit to allow the sides of the bumper to line up parrallel to the line of the wing. it seems the modding is to prevent the underside of the bumper appearing warped, unless you're very pedantic it's hardly noticable and probably not worth the effort

Does anything need to be done to the side mounts? and does anyone have the part numbers for the rs4 mounts i need to buy?